User Manual

EN
30
Operation
www.bora.com
6 Operation
 Observe all safety and warning information during
operation (see Safety chapter).
INFO The cooktops on the BORA Classic 2.0 system
can only be operated in conjunction with cooktop
extractor CKA2.
INFO The cooktop extractor must only be operated
when the grease filter components are installed.
6.1 General and specific operating
instructions
The cooktop extractor and cooktops are operated via
a central operating panel. The operating panel is fitted
with electronic sensor buttons and display panels. The
sensor buttons respond to finger contact (see Appliance
description chapter).
You operate the appliance by tapping the corresponding
sensor button with your finger (touch control) or by a
swipe of your finger (slider operation).
INFO Not all symbols are displayed on all appliances.
Functions and indicators are authorised
corresponding to the installed appliances.
6.1.1 Special operating instructions for the
Tepan stainless steel grill CKT
Initial operation:
 Heat the griddle to 220 °C for approx. 25 minutes
before using it for the first time (= power level 8 for
both grilling zones).
INFO Bothersome odours may be emitted during this
process.
Operating instructions:
INFO Clean the grill surface before using the appliance
for the first time (see Cleaning chapter).
INFO Preheat the grilling zone for 5 minutes before it is
used each time.
INFO During heating or cooling the griddle may make
some noise. This is a normal occurrence.
INFO A fan is built in to the Tepan stainless steel grill
for cooling, guaranteeing a long service life for the
electronic components and rapid cooling of the
grill surface. Different measures have been taken
to keep noise to a minimum, but it cannot be
completely avoided.
INFO During use, the griddle may show signs of
curvature.
INFO During grilling or heating on a high power level,
the griddle may adopt a light brown colour.
6.1.2 Special operating instructions for gas
glass ceramic cooktop CKG
INFO Clean the cooking zone before using the cooktop
for the first time (see the Cleaning chapter).
INFO When operating the cooktop for the first time
or after a prolonged period without use or when
the liquid gas bottles have been changed, it is
possible that the burner may not ignite. This may
be due to air in the gas pipe or the electronic
gas regulator may need recalibrating. Follow the
initial operation instructions (see Initial operation
chapter).
INFO Due to the use of enamelled cast iron parts, slight
colour variations and irregularities are common.
Furthermore, flash rust may appear at the support
points, which can be easily removed with a
damp cloth. These spots are normal and are not
considered an impairment.
INFO As a result of use, some of the components of
the gas cooktop can become discoloured. This
discolouration is normal and does not have a
negative effect on the gas flame or the functioning
of the cooktop.
INFO When using the gas burner, you may hear gas
escaping from it. The burner flame turns orange
as a result of impurities on the burner and in the
ambient air (dust). These properties are normal
and can occur independently of one another.
INFO In the event of smoke or fire while operating the
gas cooktop, turn off the gas supply and switch
off the appliance at the wall socket.
INFO If you smell gas or have problems with the gas
installation, switch off the gas supply. Open the
window and ensure good ventilation.