Installation Guide

EN
19
Installation
www.bora.com
4.4 Assembly instructions
4.4.1 Safety clearances
 Maintain the following safety clearances:
1
3
2
Fig. 4.3 Minimum distance
[1] Minimum clearance of 50 mm at the front and back from
the worktop cut-out to the edge of the worktop.
[2] Minimum clearance of 300 mm from the left and right of the
worktop cut-out to the adjacent cabinet or wall.
[3] Minimum clearance of 600 mm between the worktop and
cabinet above (650 mm in the case of gas devices).
4.4.2 Worktop and kitchen units
 Create the worktop cut-out taking into account the
specified cut-out dimensions.
 Make sure that the cut surfaces of the worktops are
properly sealed.
 Comply with the instructions of the worktop
manufacturer.

Cross bars on the kitchen unit in the area of the
worktop cut-out may need to be removed.

No false floor is necessary below the cooktop. If cable
protection (false floor) is planned, the following must
be taken into account:

It must be fitted in such a way that it can be
removed for maintenance work.

To ensure sufficient cooktop ventilation, a minimum
distance of 15 mm to the bottom edge of the
cooktop extractor is to be observed.

The drawers and/or shelves in the floor unit must be
removable.

For correct installation, the slide-in units of the
base cabinet must be shortened depending on the
installation situation.
 Do not under any circumstances install parts which are
damaged.
 Dispose of transport packaging in the proper manner
(see the Decommissioning, disassembly and disposal
chapter).
4.2.1 Scope of delivery of the cooktop
extractor
Scope of delivery CKA2 Quantity
Installation instructions 1
Operating instructions 1
Extractor base module (CKA2GM) 1
Air inlet nozzle (CKA2ED) 1
Grease filter unit (CKA2FFE) 1
Control unit (CKA2SB) 1
Power supply cable (country-specific) 1
Flexible module (CKA2MF) 1
Ferrite sleeve (UFK) 1
Tab. 4.1 Scope of delivery of the cooktop extractor
4.2.2 Scope of delivery of the cooktops
Scope of delivery CKFI, CKI, CKIW, CKCH, CKCB, CKG,
CKT
Quantity
Cooktop 1
Mounting brackets 4
Height adjustment plate set 1
Additional scope of delivery CKFI, CKI, CKIW, CKCH, CKCB
Glass ceramic cleaning instructions 1
Glass ceramic scraper 1
Additional scope of delivery CKG
Cast-iron grate 2
Nozzle set G20/20 mbar natural gas PKGDS2020 1
Flexible gas connection hose, length 500 mm, 1/2”
external thread(EN14800)
1
Cylindrical/conical transition piece 1
Seal 1
Glass ceramic cleaning instructions 1
Glass ceramic scraper 1
Additional scope of delivery CKT
Tepan spatula 1
Tab. 4.2 Scopes of delivery of the cooktops
4.3 Tools and aids
The following special tools are required to correctly install
the system:

Screwdriver/Torx screwdriver 20

Black, heat-resistant silicone sealant

Fine saw