Installation Guide

Installation

www.bora.com

Adapting the 90° bend:

Fig. 4.24 Shortening the 90° bend

[1] 90° bend

[2] Cut marks

[3] Fine saw

 Adapt the 90° bend [1] to the depth of the worktop

if necessary by shortening it accordingly at the cut

marks [2] using a fine saw [3].

Preparing the plinth fan:

 Prepare the plinth fan by attaching the sealing tape

depending on the installation situation.

 Secure the sealing tape to the inlet nozzle.

Fig. 4.25 Sealing tape position for installation with a round duct



Depending on the required connection cross-section,

you can vary the height at which the sealing tape is

attached to the plinth fan inlet nozzle.

INFO If another Universal fan module is to be used, this

must also be prepared as described here with

sealing tape on the inlet nozzle.

Fig. 4.26 Attach the seal to the plinth fan outlet nozzle.

 Push the seal onto the plinth fan outlet nozzle. The seal

will need to be stretched slightly.

Connecting the duct system

Fig. 4.27 Duct system connection

[1] Output nozzles

[2] Seal

[3] Duct part

 Pull the seal [2] onto the outlet nozzle [1] on the

appliance. The seal [2] will need to be stretched

slightly.

 Push the duct part to be connected [3] with the

coupling onto the outlet nozzle [1] with the seal [2].

 Ensure that the seal [2] is not displaced.