User Manual

EN
18
Installation
www.bora.com
≥70
Ø50 ±0,5
370
80-140
Fig. 5.8 Drill template
1
2
3
Fig. 5.9 Fitting the control knob
 Remove the knob ring [1].
 Unscrew the fixing nut [2].
 Push the control knob [3] through the hole in the panel
from the front.
 Screw the fixing nut [2] onto the control knob from the
rear and tighten a little.
 Use the marking to align the control knob [3] vertically
in the 12 o’clock position.
 Tighten the fixing nut [2].
 Slot the knob ring [1] onto the control knob [3].
Cut-out dimensions when installing cooktops or cooktops
and the cooktop extractor next to each other:
Cooktops/cooktop extractor B in mm
1/0 346
1/1 457
2/1 828
3/2 1310
4/2 1681
Tab. 5.3 Cut-out dimensions for surface mounting of appliance
combinations
5.5 Installing the cooktop
INFO Clearance of one millimetre should be planned
between the built-in appliances.
INFO A clearance of two millimetres should be planned
around the built-in appliances.
INFO It is recommended to install a mounting rail
between adjacent cooktops (mounting rail PZMS
available as an accessory).
INFO Alternatively, the cooktop can be fitted rotated by
180°.
5.5.1 Installing the control knob in the floor
unit front panel
INFO Pre-drill the bore holes to prevent tearing out the
fixed front panel.
Fig. 5.7 Installed control knob and cooktop