User Manual

EN
22
Installation
www.bora.com
X
Align the knob housing [1] so it is level.
X
Tighten the universal nut [2].
O
The wave spring (if used) must be pressed flat.
X
Remove the sticker [3].
X
Place the knob ring [4] on the knob housing [1].
5.7 Gas installation
i
Assembly, installation and commissioning must always
occur in line with national laws, regulations and
standards.
i
The work must be performed by qualified specialists who
know and comply with the additional regulations of the
local energy supply companies.
i
The gas must be connected before the cooktop is
installed in the worktop.
Ventilation
This appliance is not connected to a flue gas evacuation device.
It must be positioned and connected in accordance with the
applicable installation conditions. Suitable ventilation measures
must be particularly adhered to.
X
Always ensure there is sufficient ventilation when operating
the appliance.
5.7.1 Gas connection
45
300
53
Abb. 5.20 Position of gas connection
The gas supply is connected to the appliance using a pre-
installed elbow fitting with a 1/2” cylindrical internal thread. If,
due to national regulations, a conical connection is required, the
cylindrical/conical transition piece (provided) is to be used.
5.7.2 Connecting the gas supply
X
Turn off the gas supply.
X
Switch off the main switch/automatic circuit breaker before
connecting the cooktop.
X
Secure the main switch/automatic circuit breaker against
being switched back on without permission.
X
Make sure the power to the appliance is disconnected.
X
Check the gas type and gas pressure of the gas supply pipe.
X
Ensure that the appliance is equipped with the correct nozzle
type in order to guarantee a correct burner flame and safe
operation.
X
Remove the protective cap from the elbow fitting.
X
Connect the appliance to the gas supply.
X
Use suitable testing equipment to check all the connections
between the cooktop and the gas connection. There must not
be any leaks.
X
Create a leak test record and give this to the user.
5.7.3 Additional installation notes for
Australia and New Zealand (AU/NZ)
i
Observe the requirements on the installation of the
appliance pursuant to AS/NZS 5601.1: minimum
clearance of the gas burner head from flammable
surfaces.
i
Installation must only be carried out by authorized
personnel.
X
In addition, adhere to the requirements of the currently
applicable version of the regulations and AS/NZS 5601.1 .
X
Further technical requirements are considered:
AS/NZS 5263.1.1 Gas appliances - Domestic gas cooking
appliances (AU/NZS ).
X
Check the different scope of delivery (see scope of delivery of
the cooktops)
O
The connection to a rigid and bend-resistant pipe must be
established as specified in AS/NZS5601.1.
O
Pursuant to AS/NZS 1869 (certified to AS/NZS 1869), the
connection to a hose for gas must have a diameter of 10mm,
a class B or D classification in accordance with AS/NZS 1869
and a maximum length of 1,200mm in accordance
with AS/NZS 5601.1.
Natural gas (NG)
If the cooktop is connected to a natural gas (NG) supply, a gas
regulator must be installed with a test point.
The gas regulator comes with the appliance.
Abb. 5.21 Gas regulator (NG)
X
Attach the gas regulator to the gas cooktop connection.
X
Note the gas flow direction of the gas regulator.