User Manual

EN
53
Cleaning and Maintenance
www.bora.com
 Take hold of the activated charcoal filter [2] by the grip
strap [1] and pull it out as far as possible through the
filter housing opening.
Fig. 8.7 Removing the activated charcoal lter through the
inlet opening
 Take hold of the end of the activated charcoal filter and
pull upwards and towards the left until it is completely
out of the inlet opening.
8.6.2 Inserting the activated charcoal filter
OBEN / TOP
2
1
Fig. 8.8 Activated charcoal lter
[1] Activated charcoal filter
[2] Grip strap
 Remove the packaging from the activated charcoal
filter [1].
 Position the activated charcoal filter correctly with the
help of the printed symbols (arrow left, grip strap [2]
right).
 Hold the activated charcoal filter at both ends.
 Bend the activated charcoal filter into a cylindrical
shape so that both ends of the filter are opposite each
other.
8.6 Replacing the activated charcoal
filter
An activated charcoal filter will only be fitted with the
stainless steel grease filter if the cooktop extractor is
used in recirculation mode. The activated charcoal filter
absorbs cooking odours that arise during cooking.
INFO The activated charcoal filter must be replaced
when the fan indicator shows
F
(Filter service
indicator). You can obtain the activated charcoal
filter PUAKF from your specialist supplier or by
contacting BORA via the website at www.bora.
com/filter.
 Make sure that the cooktop and cooktop extractor are
switched off (see the Operation chapter).
 Wait until the fan power level indicator shows
0
.
8.6.1 Removing the activated charcoal filter
 Remove the air inlet nozzle and stainless steel grease
filter.
2
1
Fig. 8.5 Remove the lter replacement cover
[1] Filter replacement cover
[2] Inlet opening
 Inside the inlet opening [2] pull the filter replacement
cover [1] out through the opening in the filter housing.
2
1
Fig. 8.6 Removing the activated charcoal lter from the lter
housing
[1] Grip strap
[2] Activated charcoal filter