Operation Manual

77
NL
FR
ES
EN
For the Installer
General Installation Instructions
Your Boretti must be installed by a qualifi ed tech-
nician according to legal/locally applicable codes
and ordinances.
Before you start installation or reparation work,
make sure that the range cooker is not connected
to the power source.
Your Boretti can be installed against a wall that is
higher than the counter, such as a tall appliance
cabinet or a closed wall, at a distance of at least
50 mm from the side of the range cooker, as illu-
strated in Drawing A. There must be at least 650
mm of space between the cooktop and any shelf
or hood placed above it.
Your Boretti range cooker has a standard height
of approximately 91 cm. If your Boretti has been
fi tted with round adjustable legs, you can also
purchase these in a taller version. The range
cooker can then be adjusted to a height between
91 and 97 cm. It is recommended to align the
cooktop with the top of the counter. We also re-
commend that the range cooker be perfectly level
in order to ensure proper functioning.
The strip with ventilation slots included with your
range cooker is only mandatory for use with a
ventilated gas oven, and only when it is closed off
on the upper–back side by tiles or a wall. You do
not need to use these for a model with a regular
electric oven; that range cooker can be placed
directly against a back wall or tiles.
In order to ensure proper functioning, we advise
you to use your range cooker in a well–ventilated
area. This is especially important for range coo-
kers that are connected to bottled gas (butane/
propane). Butane/propane (bottled gas) is heavier
than air. As a result, the gas will sink low to the
ground (only in case of leakage). Therefore, there
must be suffi cient ventilation to disperse gas at
ground level. Under no circumstances may the
gas bottles be placed below the living area (base-
ment/crawl space). This also applies to empty or
half–empty gas bottles.
Electrical Connection
Check whether voltage and capacity agree with
the features mentioned on your Boretti’s type
plate. Under no circumstances may this plate be
removed. The fuses and home mains voltage in-
stallation must comply with the range cooker’s
requirements. The connection to the electrical
supply may be either fi xed, or a plug and socket.
In the latter case, the plug and socket outlet must
comply with applicable regulations. The connec-
tion must be grounded, regardless of type. Befo-
re connecting, make sure the electricity source is
properly grounded. Avoid use of reducers, adap-
tors, extension cables or by–passes.
Caution:
See Page 98 for the correct installation diagrams.
All six screws must always be well tightened.