Owner's manual

ManualsBrandsBorg Locks ManualsFor HomeBL 2605MG Series

FACTORY

PRE-SET CODE

‰

Parts List,

Installation

and

General

Information

„

†

 ‚

Please make sure you have received all the

following parts:

(1) Keypad

(2) Inside lock body

(3) Neoprene seals x 2

(4) Spindles

(5) Surface lock keep

(6) Morticed lock keep

(7)Wood screws x 8

(8) Tweezers (For changing the code)

(9) Fixing bolts. 6 supplied

(10) Spare tumblers. 2 x Coded

2 x Uncoded

(11) Code card

…

‡

PARTS LIST

.1.

BL2605MG

Summary of content (4 pages)

PAGE 1
Parts List, Installation and General Information ‚ BL2605MG ƒ PARTS LIST Please make sure you have received all the following parts: (1) Keypad (2) Inside lock body (3) Neoprene seals x 2 (4) Spindles (5) Surface lock keep (6) Morticed lock keep „ … (7)Wood screws x 8 (8) Tweezers (For changing the code) (9) Fixing bolts. 6 supplied † (10) Spare tumblers. 2 x Coded 2 x Uncoded ‡ (11) Code card ˆ ‰ Š 11 FACTORY PRE-SET CODE .1.
PAGE 2
SPECLAL NOTES HOW TO CHANGE YOUR CODE NUMBER Before commencing installation check that all parts are working correctly: Press the code according to the code card and then the knob should turn and return easily under spring pressure. lf you intend to change the code, you should do it before installing the lock, See the code change instructions. 1) Remove the lock from the door . 2) Remove the 2 retaining screws from the back of the keypad.
PAGE 3
Assembling and Fitting Keypad · · Inside lock body Surface lock keep · · Surface lock keep · Morticed lock keep Unscrew the four screws and remove the plate Right Left Dead bolt Dead bolt Plate to be removed .3.
PAGE 4
MAINTENANCE INSTRUCTIONS WEEKLY CLEAN THE SURFACE OF THE LOCK WITH MARINE GRADE CHROME POLISHING LIQUID. SPRAY THE EXPOSED PARTS OF THE LATCH WITH WD40 OR EQUIVALENT. ANNUALLY 1. REMOVE THE LOCK FROM THE DOOR. 2. SPRAY THE INSIDE OF THE LOCK THOROUGHLY WITH WD40 OR EQUIVALENT, THROUGH THE TUMBLER HOLES AT THE BACK OF THE LOCK. 3. SPRAY ALL THE FIXING ACCESSORIES AND THE LATCH WITH WD40 OR EQUIVALENT. 4. PUSH EACH OF THE BUTTONS AND ROTATE THE KNOB SEVERAL TIMES TO MAKE SURE THE LOCK IS WORKING SMOOTHLY.