Owners manual

BORLA PERFORMANCE INDUSTRIES
701 Arcturus Ave.
Oxnard, Ca. 93033
805-986-8600
TITLE: Chevrolet Corvette C6 Rear Section
Installation Instructions
PART NO. A-35631 Rev.A Page 3 of 4
Caution!!! Never work on a hot exhaust system. Serious injury in the form of burns can result If the vehicle has been in use and the exhaust system is hot,
allow vehicle to cool for at least 1 hour. Always wear eye protection when working under any vehicle.
Note: It is our recommendation that you use a hoist or hydraulic lift to facilitate the installation of your new Borla Performance Rear Section Exhaust System.
Taking all under car safety precautions, lift the vehicle using a hoist or hydraulic lift. Once this has been done, you may begin the removal of your old exhaust
system from your vehicle.
Note: Before removing the original exhaust system from your vehicle, please compare the parts you have received with the bill of materials provided on the
previous page to assure that you have all the parts necessary for the installation of your new Borla Performance Rear Section Exhaust System.
Original Exhaust System Removal
Note: With a used vehicle, we suggest a penetrating spray
lubricant to be applied liberally to all exhaust fasteners and
allowing a significant period of time for the chemical to lu-
bricate the threads before attempting to disassemble.
1. Loosen the clamps on the pipe in front of the rear axle. Remove
the hardware on the hangars connecting the pipe to the vehicle.
Keep this hardware for installation of your new exhaust sys-
tem. (See Fig. 1)
2. Carefully remove the rear mufflers from the rubber isolators.
(See Fig. 2)
Warning: Use extreme caution during installation. Torque all
fasteners according to manufacturer’s torque values and tighten-
ing sequence. DO NOT use air impact tools to tighten fasteners
on Borla Performance Exhaust Systems. Use of such tools may
result in bent flanges or gasket contact areas leading to exhaust
Figure 1
Figure 2