Owners manual

BORLA PERFORMANCE INDUSTRIES
701 Arcturus Ave.
Oxnard, Ca. 93033
805-986-8600
TITLE: Chevrolet Corvette C6 Rear Section
Installation Instructions
PART NO. A-35631 Rev.A Page 4 of 4
Borla Performance Rear Section
Exhaust System Installation
1. Place a clamp over each expanded ends of each Over-Axle Pipe.
Starting with the R/H Muffler Assembly, and insert inlet into R/H
Over-Axle Pipe and carefully insert hangars into runner isolators.
Repeat step for the L/H Muffler Assembly. (See Fig. 3 & 4)
2. Check your exhaust system for proper clearance under the vehicle
and also for tip alignment. Starting at front flanges and moving to
rear of vehicle, tighten flange hardware bolts. Orient position of
bolt (on supplied clamps) between (not over) pipe notches and
tighten to 35 ft. lbs. torque. (See Fig.5)
3. Align tips and tighten hardware. Loosen clamps to rotate or slide
pipe for better alignment. (See Fig. 6)
4. Before starting your vehicle, make sure to check all wires, hoses,
brake lines, body parts and tires for safe clearance from the exhaust
system.
5. Start vehicle and check for any leaks. If any leaks are found, deter-
mine cause (such as loose or incorrectly positioned clamp) and re-
pair as necessary.
Congratulations!!! You have completed the installation of the
world famous Borla Performance Stainless Steel Exhaust System.
Note: When you first start your vehicle after the installation of your
new Borla Performance Exhaust System, there may be some smoke
and fumes coming from the system. This is a protective oil based
coating used in the manufacturing of mandrel bent performance
exhaust tubing. This is not a problem and will disappear within a very
short period of time after the exhaust has reached normal operating
temperatures.
Figure 4
Figure 3
Figure 5
Figure 6