Use and Care Manual

ManualsBrandsBorroughs ManualsGarage ShelvingRivet-Span 60 in. W x 84 in. H x 12 in. D Black Steel 3-Level Tire Rack

- 1 -

Rivet-Span.

Installation Instructions

32-50500-000A

SEPTEMBER 1996

BORROUGHS CORPORATION

3002 N. BURDICK STREET • KALAMAZOO, MI 49004-3483

800-748-0227 • FAX 616-342-4161 • CANADA 800-968-0162

Bulk Storage Unit

Angle Post

Support Tie

Shelving Unit

Double

Rivet

Angle

Beams

Single Rivet

Beam

Angle

Post

5/8" Thick

Particle Board

Decking

Double Rivet

Angle Beams

Foot Plate

Angle Post

Single Rivet

Beams

Double

Rivet

Angle

Beams

Double Rivet

Angle Beams

Angle Post

Double Rivet

Angle Beam

Double Rivet

Channel Beam

5/8" Thick

Particle

Board

Decking

IMPORTANT - PRODUCT LIABILITY INFORMATION

READ ALL INSTRUCTIONS BEFORE PROCEEDING WITH ASSEMBLY. VITAL PRODUCT INFORMATION PERTAINING TO

PROPER SETUP AND CAUTIONS ARE INCLUDED. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN

PERSONAL INJURY AND/OR PROPERTY DAMAGE.

RETAIN THIS MANUAL FOR FUTURE REFERENCE

SR= Single Rivet Beams

LP = Double Rivet Low Profile Beams

DR =Double Rivet Angle Beams

ZB= Double Rivet Z Beams

DH =Double Rivet Angle Beams with Support Tie

CH =Double Rivet Channel Beams with Support Tie

PR= Punched Double Rivet Angle Beams

(to accept record storage support angles)

PH= Punched Double Rivet Channel Beams with Support Tie

(to accept record storage support angles)

Pre-configured Catalog Units

B 7 2 2 4 D R 4 7

Starter or Adder Unit

Depth of Unit in Inches

Width of Unit in Inches

B = Starter; A = Adder

Type of Beam

Number of Beam Levels

Height of Unit in Feet

Part Numbering System

Support Tie

Summary of content (4 pages)

PAGE 1
Rivet-Span.
PAGE 2
General Instructions: 1. 2. 3. Check parts and bundles against packing slip to be sure all parts and bundles were received. Sort parts so that like parts are together. This will make installation easier and faster. Read through the entire instructions carefully - before attempting to assemble the units. Tools Required: 1. 2. Rubber mallet or a hammer and block of wood. Two pairs of pliers or two 7/16" wrenches for installing Foot Plates and/or Support Ties.
PAGE 3
Bulk Storage Unit / Shelving Unit: Beams are installed by placing both of the rivets in post slots, making sure the rivets are engaged, then striking the beam with a rubber mallet (or by placing a block of wood over the beam, to protect the finish, and striking with a hammer). See Figure 1. Make sure both rivets are fully seated on the bottom of the post.
PAGE 4
Bulk Storage Unit: Support Ties - Optional Support ties are used with the bottom and top level left-to-right double rivet angle and channel beams. They are installed from front-to-back as shown in Figure 4. Beams under 96" use (1) support tie in the middle of the beam while 96" beams use (2) support ties dividing the beam into thirds. Intermediate Beam Levels FIGURE 4 All units must have double rivet beams, left-to-right and front-to-back, installed at every level.