Installation Guide

All information is subject to change without notice Page 8 of 12
Borroughs Document Number: DOC-MDC-0011 Rev. 2.0
www.borroughs.com 1-800-748-0227
Footrest for Basic Work Bench
STEPS
Place footrest on shelf supports between legs of work bench with open area of footrest channel facing
downward. Position footrest so that the inner holes, in each end of footrest, are in line with inner holes in
each shelf support (NOTE: Footrest can be positioned at any one of four (4) locations in the shelf
supports). Fasten footrest to shelf supports with two (2) screws, washers, and nuts as provided, one (1)
each end. This completes the Footrest assembly for Basic Work Bench.
Footrest for Continuous Bench with Common Leg
Place footrest on shelf supports between legs of work
bench with open area of footrest channel facing
downward. Position footrest so that the inner hole, in
the end of footrest on end shelf supports, is in line
with the inner hole of shelf support.
The outer hole, in footrest end, that is sitting on
common shelf support is to be aligned with inner hole
in the common shelf support. (NOTE: The footrest
can be positioned at any one of four-hole locations on
the shelf supports). Fasten footrest to the shelf
supports with two (2) screws, washers, and nuts as
provided. Repeat procedure with the other footrest
on the other side of the common shelf support.
If more than two (2) benches will be strung together
in a continuous row, with a common leg between each, the outer hole in footrest will always align with
respective inner hole in the common shelf support. This completed the footrest assembly for the
Continuous Work Bench with Common Leg.