Installation Guide

All information is subject to change without notice Page 5 of 12
Borroughs Document Number: DOC-MDC-0011 Rev. 2.0
www.borroughs.com 1-800-748-0227
Workbench with All-Wood Top
Do not tip bench on its side, without a shelf attached as it is unstable and may cause
damage. Must use two people to rotate bench.
STEPS
Attach stringer to leg weldment. Position stringer so that holes in end
of stringer are in line with holes in legs; locate approximately 11-5/8”
down from top of leg weldment. Fasten stringer to leg with four (4)
07792-00 screws and 100530-00 weldnuts provided. Repeat step for
opposite end.
Lay bench top face down on a flat clean surface; such as blanket or
cardboard to protect from scratching
Place leg weldment and stringer assembly upside down on bench
top. Stringer should be placed toward back edge of bench top.
Position leg weldment and stringer assembly so it is centered on
bench top and legs are parallel to end of bench. Use leg weldments
as templates and drill eight (8) 1/4” pilot holes x 1” deep for lag
screws at each end of bench top. Fasten leg weldment and stringer
assembly to bench top with eight (8) .312 (5/16”) x 1” lag screws.
NOTE: Lag screws are not furnished by manufacturer.
Insert adjustable foot into leg so that holes in the sides of foot are
aligned with holes in sides of leg. At desired height, fasten foot to leg with
four (4) 07792-00 screws and 17213-00 nuts. Repeat procedure for other
legs. Tighten all hardware. This completes assembly of Basic workbench.
Put bench in upright position.
Leg
Stringer