Instructions / Assembly
5
Borroughs Document Number: DOC-ECM-0001
1
1
-
5
/
8
"
B
A
C A
1. Stand one Leg Frame up
on the floor with legs
facing upward.
2. Align end holes in
Stringer to holes in Leg
Frame at approximately
11-5/8”.
Basic Workbench
Stringer to Leg Frames
3. Loosely fasten together with (4) screws and (4) weldnuts.
4. Repeat Steps 1-3 to the other leg Frame on opposite end of the Stringer. Tighten all hardware.
“NOTE” - This completes the Leg Frame Assembly.
Leg Channels to Steel Top
(Skip step for wood top)
“NOTE” - Peel off protective film if
stainless tops are being used.
1. Lay Top face-down on flat,
clean surface such as a blan-
ket or the cardboard packaging.
2. Insert Leg Channel into end of
top with open area of channel
facing upward.
3. Align Leg Channel holes with
obround and first hole of top
flange.
4. Loosely fasten together with (4)
screws and (4) Nuts.
5. Repeat steps 2-4 to other Leg
Channel on opposite end of top.
Tighten all hardware.