TV DVD Combo User Manual

Turn on the AC power
2
1
You must follow the power sequence in the order shown for turning on AC power to
controller-drive trays and drive trays that use AC power. To establish power redundancy for
trays with two power supplies, use at least two different power distribution units (PDUs) in
the cabinet. Split the power connections from each tray into the separate PDUs. Then connect
the PDUs to external power receptacles that are on different circuits.
!
Warning!
Risk of bodily injury
Each tray has more than one power cord. To remove all electrical current from the devices,
make sure that all of the power cords are disconnected from the power source.
i
Notice!
You must turn on the power to all connected drive trays before you turn on the power to the
E2600 controller-drive tray. Performing this action makes sure that the controllers recognize
each attached drive tray.
1. Turn off all of the Power switches from the rear of the storage array, and make sure that
all of the power cords are connected.
2. If the main AC circuit breaker switches in the cabinet are not already turned on, turn on
the circuit breaker switches.
3. Turn on the Power switch on each power-fan canister in all of the installed drive trays.
4. Turn on the Power switches on each power-fan canister in the E2600 controller-drive tray.
Note:
When turning off the power to the storage array, perform the procedure in the reverse
order. Turn off the power fi rst to the controller-drive tray, and then turn off the power to
the drive trays.
8
E2600 DSA E-Series iSCSI Disk Arrays Turn on the AC power | en 15
Bosch Sicherheitssysteme GmbH Quick Install Guide 07/2012 | V1 |