CCS 800 Ultro Installation and Operating Manual en Discussion System Manuel d’installation et d’utilisation fr Système de Discussion Installations- und Bedienungshandbuch zh-t de zh-s es th nl Diskussionssystem Manual de instalación y funcionamiento Sistema de Conferencias Installatie- en gebruikshandleiding Discussiesysteem Installazione e Manuale operativo ja it Sistema audio congressuale
Page en.............................................................................................3 Prior to installing or operating this product always read the Safety Instructions which are available as a separate document. fr ............................................................................................24 Avant d 'installer ou d'utiliser ce produit, lisez toujours les Instructions de sécurité disponibles dans un document distinct. de ...................................................
CCS 800 Ultro | Installation and Operating Manual 1 About this manual en | 5 2 Introduction This "Instructions For Use" manual provides all the information required to install and operate the CCS 800 Ultro Discussion System. The CCS 800 Ultro Discussion System is a discussion system for use in meeting and conference venues with a limited number of participants. Conventions A CCS 800 Ultro Discussion System consists of: • One Control and Power Supply Unit (CPSU).
CCS 800 Ultro | Installation and Operating Manual 3 Control and power supply unit (CPSU) CCS 800 UL TRO 2 3 4 1 2 3 1 4 4 3 5 6 7 2 1 0 8 10 4 3 9 5 6 7 2 1 0 8 10 9 1 2 3 Microphone Trunk in/out Recorder 4 Line 5 6 Telephone Insertion In Gain Out Gain Digital Acoustic Feedback Suppression 90-260 V~ 7 8 9 11 13 14 10 12 en | 6 4 Speaker volume control of all connected delegate and chairman units. 5 Volume control of the speaker or headphone of the CPSU.
CCS 800 Ultro | Installation and Operating Manual 14 Mains input connection. Use the included mains cord to connect the CPSU to the mains socket. In some countries it may be necessary to replace the supplied mains cable by a local one. Brown = live, blue = neutral and green/yellow = earth. (Replacement and colour indication not applicable to mains cords for North America). 4 Delegate and Chairman unit en | 7 9 Chairman Priority button.
CCS 800 Ultro | Installation and Operating Manual en | 8 5.2 Connecting up to 150 units CCS 800 Ultro can be used with up to 150 units by adding maximum 2 additional control units acting as power supply units only. The system is controlled by the master LBB 3310. The cables necessary for these connections can be delivered by your local dealer. max.
CCS 800 Ultro | Installation and Operating Manual 5.5 Connecting a wireless microphone Trunk in/out Microphone Recorder Line Telephone en | 9 Connect the cabling of the tape recorder (2) to the recorder input and output of the CPSU (1). Use the gain control (3) to adjust the sensitivity of the recorder input of the CPSU. Insertion In Gain Out Gain Digital Acoustic Feedback Suppression 90-260 V~ 5.
CCS 800 Ultro | Installation and Operating Manual 5.8 Connecting a telephone coupler 1 Recorder Line en | 10 5.9 Connecting an equalizer 1 Telephone Insertion Recorder Line Telephone Insertion In In Gain Gain Out Gain Out Gain 3 4 2 2 3 4 Figure 5.8 Figure 5.9 Connect the telephone coupler (2) to the telephone input and output of the CPSU (1). The telephone coupler is further connected to the telephone wall socket (4) and a telephone (3) for dialing.
CCS 800 Ultro | Installation and Operating Manual 6 en | 11 Operation 6.1 Testing the connection of the delegate and chairman units 3 CCS 800 ULTRO 3 2 1 4 1 4 2 5 6 3 3 4 4 8 9 1 0 10 5 1 2 2 3 1 4 6 3 7 2 4 7 2 8 9 1 0 10 Figure 6.1 Put the mode selector in the test position, all light-ring indicators and LEDs of the delegate and chairman units must lit if properly connected. 6.2 Using the microphone button of the delegate unit Figure 6.
CCS 800 Ultro | Installation and Operating Manual en | 12 6.3 Using the microphone button of the chairman unit 1...4 1...4 Figure 6.3 Pressing the microphone button on a chairman unit always activates the chairman microphone, independent of the selected microphone mode. Chairman units don't switch off automatically. 6.5 Priority mode settings in chairman unit 0 I I 0 6.4 Using the priority button 1 A A 1 1 2 2 B B Figure 6.
CCS 800 Ultro | Installation and Operating Manual en | 13 6.6 Open mode Select the max. number ( 1, 2, 3 or 4) of delegate microphones which can be active at the same time. Note Chairmen can always switch on and off their microphones and are not included in the max. number. 4 3 1 2 2 3 1 4 CCS 800 ULTRO 3 4 1 4 2 2 3 1 4 5 4 5 6 3 7 7 2 8 9 1 0 1...4 6 3 2 8 9 1 0 10 10 1...4 Figure 6.6 themselves at the same time. If the speaker is silent for approximately 30 sec.
CCS 800 Ultro | Installation and Operating Manual en | 14 6.8 Override mode 3 4 1 2 2 3 1 4 CCS 800 ULTRO 3 4 1 4 2 2 3 1 4 6 4 5 7 2 8 8 9 1 0 10 A Each time a delegate presses the microphone button on a delegate unit, it will override the currently active delegate unit. So only one delegate microphone is active at the same time. Chairman microphones can always be switched on. 6.
CCS 800 Ultro | Installation and Operating Manual en | 15 6.10 Volume control of the delegate and chairman units 4 5 6 3 7 2 3 4 1 4 2 2 3 1 4 5 5 6 3 4 8 9 1 5 0 6 3 7 2 0 4 8 9 1 0 10 4 7 9 0 5 6 3 7 1 9 2 8 1 8 0 10 1 10 7 2 10 6 2 9 1 CCS 800 ULTRO 3 8 2 10 1 2 Figure 6.10 Turn the volume control (1) to set the volume of the loudspeakers of the delegate and chairman units (2). Adjust for maximum level without feedback.
CCS 800 Ultro | Installation and Operating Manual en | 16 6.12 Monitoring volume control 5 4 6 3 7 2 9 1 CCS 800 ULTRO 3 4 1 4 2 2 3 1 4 5 6 3 4 8 9 1 10 5 0 6 3 7 2 0 CCS 8 7 2 8 9 1 0 10 CCS 800 UL TRO 2 3 4 10 800 UL TRO 1 2 2 3 1 3 4 1 2 3 1 4 4 3 5 4 6 7 2 1 0 4 3 5 6 7 2 8 10 4 3 9 1 0 5 6 7 2 1 0 8 10 4 3 9 9 5 6 7 2 1 0 8 10 8 10 9 Figure 6.12 Use the built-in loudspeaker or a headphone to monitor the discussion.
CCS 800 Ultro | Installation and Operating Manual 7 Troubleshooting Temporary no microphone reaction, and no sound or distorted sound from unit loudspeakers en | 17 Part of system not working • • • • Possible cause Trunk-line overload. Solution Reduce load on the trunklines by reducing the number of units, and/or the length of the trunk cables. No sound via delegate/chairman loudspeakers • Acoustic Feedback • • • • • • • Possible cause Loudspeaker volume too loud.
CCS 800 Ultro | Installation and Operating Manual 8 Technical data 8.1 System Electrical and ElectroAcoustical Characteristics 8.1.1 The CPSU Mains voltage: 100 - 240 Vac, ± 10%, 50/60 Hz Current consumption: max. 0.9 A (100 Vac) - 0.
CCS 800 Ultro | Installation and Operating Manual en | 19 8.1.2 Combined Units 8.3 General Data Delegate microphones with transmission links to delegate headphones and auxiliary outputs. 8.3.1 System Environmental Conditions General Frequency response: Temperature range Storage and transport: -20 to +70°C (-4 to +158°F) Operational: +5 to +45°C (+41 to 113°F) 125 Hz - 12.5 kHz tolerances acc. to IEC 914 standard Total harmonic distortion at overload at nominal input level (85 dB SPL): < 0.5% at max.
CCS 800 Ultro | Installation and Operating Manual 8.3.
CCS 800 Ultro | Installation and Operating Manual 9 en | 21 Appendix 9.1 Pin Configuration CCS 800 ULTRO 3 4 1 4 2 2 3 1 4 Microphone Recorder Line Telephone 6 4 5 6 3 7 8 9 1 0 Trunk in/out 5 3 2 7 2 8 9 1 0 10 10 Insertion In Gain Out Gain Digital Acoustic Feedback Suppression 90-260 V~ 7 2 6 1 3 3 5 2 A 4 2 1 B 1 C 1 2 3 D 123 E A Figure 9.1 9.1.1 Trunk Connections (A) 9.1.
CCS 800 Ultro | Installation and Operating Manual 9.1.5 Headphone Jack-plug (3.5mm) (E) 1 Tip 2 Ring 3 Sleeve - Signal + - Signal - Electrical earth/screen 9.1.6 Mounting of connectors, LBB 3316/00 Yellow en | 22 9.2 Mounting Instructions The CPSU can be attached in three different ways: • In a 19" rack making use of the 19" rack mounting set LBB 3311/00. Place a blank 1HU panel above the CPSU to have sufficient space for cable connections. • Mounted into a table using the flush mount bracket.
CCS 800 Ultro | Installation and Operating Manual en | 23 9.3 Bracket for Flush Mounting The drawing below gives the necessary information how to make a bracket for flush mounting the CPSU into a table. 2+0.2 52 0.5 90˚ ø8.6(4x) 3.7 (2x) 4.6 (2x) 130 50.3 234.5 135 95.8 175 2.5 (6X) R=2 +0.5 0 (4x) 4+0.5 0 (4x) Figure 9.5 Bosch Security Systems | 2003-06 | 3922 988 54284 461 342.5 421 328.5 362+0.5 0 7 59.3 49.5 20 6 47.8 64 29.
For more information please visit www.boschsecuritysystems.com © 2003 Bosch Security Systems B.V.