Security Camera User Manual
Table Of Contents
- Table of Contents
- 1 Safety
- 2 Introduction
- 3 System Information
- 3.1 Network video server
- 3.1.1 Progressive scan
- 3.1.2 True Day/Night function
- 3.1.3 Multiple streams
- 3.1.4 ONVIF (Open Network Video Interface Forum)
- 3.1.5 Audio
- 3.1.6 Alarm I/O
- 3.1.7 Tamper detection and motion detection
- 3.1.8 Video encoding
- 3.1.9 Multicast
- 3.1.10 Power-over-Ethernet
- 3.1.11 Encryption
- 3.1.12 Recording
- 3.1.13 Configuration
- 3.2 Operation with external systems
- 3.1 Network video server
- 4 Planning
- 5 Installation
- 6 Camera configuration
- 7 Browser connection
- 8 Troubleshooting
- 9 Maintenance
- 10 Technical Data
FLEXIDOME HD VR Troubleshooting | en 37
Bosch Security Systems Installation Manual AM18-Q0637 | v1.1 | 2013.08
No audio
transmission to
remote station.
Hardware fault. Check that all connected
audio units are operating
correctly.
Faulty cable connections. Check all cables, plugs,
contacts and
connections.
Incorrect configuration. Check audio parameters
on the Audio
configuration and
LIVEPAGE Functions
pages.
The audio voice
connection is already in
use by another receiver.
Wait until the connection
is free and then call the
sender again.
The unit does not
report an alarm.
Alarm source is not
selected.
Select possible alarm
sources on the Alarm
sources configuration
page.
No alarm response
specified.
Specify the desired alarm
response on the Alarm
connections
configuration page; if
necessary change the IP
address.
The unit is not
operational after a
firmware upload.
Power failure during
programming by firmware
file.
Have the unit checked by
Customer Service and
replace if necessary.
Incorrect firmware file. Enter the IP address of
the unit followed by /
main.htm in your Web
browser and repeat the
upload.
Malfunction Possible causes Solution