user manual

2
Bosch Security Systems | 04-2003 | 3922 988 43318 en
Digital Congress Network | Installation and Operating Manual | Chapter 4 - Central Control Equipment
en | 4-8
CU Protocol and Serial Port settings
4.6 CU Protocol and Serial Port settings
For location of DIP-switches see FIG 4-3 and FIG 4-5.
4.6.1 LBB 3500/05 Port 1 for Camera Control
In a single (stand-alone) CCU system only one COM-port (Port 1) is available: Default settings are;
8 data bits
No parity check
1 Stop bit
4.6.2 LBB 3500/15 and LBB 3500/35 (TCB 4) - Port 1 : DCN Control PC
Port 2 : Camera Control
In a single (stand-alone) CCU systems two serial COM-ports (Port 1 and Port 2) are available.
Both ports can be individually configured. Default settings are;
8 data bits
No parity check
1 Stop bit
NOTE: It is possible to select ‘Full’ protocol on both Port 1 and Port 2. However this is NOT
recommended due to processing power and memory limitations.
Table 4-5: LBB 3500/05 Protocol settings
DIP-switch S14D RA Port 11
Switch Switch
DP-1 DP-2
Not applicable OFF OFF
Terminal OFF ON
Not applicable ON OFF
Camera control* ON ON
* default settings for LBB 3500/05
Table 4-6: LBB 3500/05 Baud rate settings
DIP-switch S14 Port 1
Switch Switch
DP-3 DP-4
9.6 K OFF OFF
19.2 K* OFF ON
57.6 K ON OFF
115.2 K ON ON
* default settings for LBB 3500/05
DIP-switch S14: Port 1 (default settings)
S14
ON
87654321
5 - 8
Not used
Table 4-7: LBB 3500/15 and LBB 3500/15 Protocol settings
DIP-switch S14 Port 1 Port 2RT
Switch Switch Switch Switch
DP-1 DP-2 DP-5 DP-6
Simple (Open interface) OFF OFF OFF OFF
Terminal OFF ON OFF ON
Full ON* OFF* ON OFF
Camera control ON ON ON* ON*
* default settings for LBB 3500/15 and LBB 3500/35
Table 4-8: LBB 3500/15 and LBB 3500/35 Baud rate settings
DIP-switch S14 Port 1 Port 2
Switch Switch Switch Switch
DP-3 DP-4 DP-7 DP-8
9.6 K OFF OFF OFF OFF
19.2 K OFF ON OFF* ON*
57.6 K ON OFF ON OFF
115.2 K ON* ON* ON ON
* default settings for LBB 3500/15 and LBB 3500/35
DIP-switch S14 (default settings)
ONS14
87654321
Port 1 default
ONS14
87654321
Port 2 default