AXXIS WTA 3510 Electric Vented Dryer AXXIS WTL 5410 Electric Condensation Dryer Internet: http://boschappliances.
Use and Care Manual Installation Instructions IMPORTANT SAFETY INSTRUCTIONS . . . . . . 4 GROUNDING INSTRUCTIONS . . . . . . . . . . . . . . 5 ABOUT YOUR DRYER . . . . . . . . . . . . . . . . . . . . . 6 GETTING TO KNOW YOUR DRYER . . . . . . . . . ENERGY SAVING TIPS . . . . . . . . . . . . . . . . . . OPERATING TIPS . . . . . . . . . . . . . . . . . . . . . . . 6 7 7 BEFORE USING FOR THE FIRST TIME . . . . . . 7 GETTING STARTED . . . . . . . . . . . . . . . . . . . . . . .
Use and Care Manual IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electric shock, serious injury or death to persons when using your dryer, follow basic precautions, including the following. 1. Bosch dryers are provided with an Use and Care Manual and an Installation Instruction manual. Read all instructions before using the dryer. 2.
IMPORTANT SAFETY INSTRUCTIONS (continued) 21. Replace worn power cords and/or loose plugs. 22. Do not operate the dryer with any guards and/or panels removed. 23. Do not operate the dryer with missing or broken parts. 24. Do not bypass any safety devices. 25. Do not use plastic or non-metal flexible duct with this dryer. Plastic or non-metal flexible duct presents a potential fire hazard. Notes: 26.
Figure 1. ABOUT YOUR DRYER Congratulations on having selected a Bosch clothes dryer, the choice of those that demand exceptional performance from their clothes dryer.
ENERGY SAVING TIPS OPERATING TIPS To save energy, time and money, Bosch recommends the following: Follow the fabric care labels on the clothing. Avoid very small loads. When only one or two items need drying, add a few similar items to improve drying efficiency. Do not mix heavyweight and lightweight clothing. Do not dry wool or fabrics with a wool content Always spin dry the laundry in the washer at the highest recommended speed for the fabric type.
CYCLE SELECTION CHART (Recommendations) Drying Level Setting Cotton or linen items (whites and coloreds), full load * Note: For heat-sensitive items press the ‘‘Delicates’’ button. Regular/Cott.
3. Load the dryer For best results it is recommended that the drying load be sorted by fabric type and desired dryness level. Also, close all zippers, hooks and eyelets and tie loose belts and apron strings, etc. before placing in the dryer. a. Depress the ‘‘Door’’ button. The door will open and the drum light will turn on. b. Check the drum interior for foreign objects or pets and remove any used fabric softener sheets. c. Place laundry items to be dried loosely into the drum of the dryer. 4.
7. Select ADDITIONAL FUNCTIONS, if desired The additional functions available are accessible by depressing the buttons: ‘‘Delicates’’ The ‘‘Delicates’’ button, see Figure 5, will reduce the drying temperature and lengthen the drying time when depressed. It is recommended that the ‘‘Delicates’’ button be depressed when drying heat sensitive fabrics, such as, acrylics. Be sure to follow the instructions listed on the care label instructions.
CARE and CLEANING The housing and control panel should only be cleaned with a soft cloth rinsed in soapy water, or with a solvent free, non-scouring cleaning agent. Other areas requiring periodic cleaning or maintenance are listed below: Lint Filter The lint filter should be cleaned after each use or If the ‘‘Lint Filter’’ light becomes illuminated and the buzzer sounds during operation of the dryer: Figure 7. 1. Immediately stop the dryer by depressing the ‘‘On/Off’’ button. 2.
Moisture Sensor Frost Protection (WTL models only) Occasionally the moisture sensors will need cleaning, due to a build-up of a fine layer of lime scale on the inside of the drum. This build-up of lime scale can be easily removed by wiping the sensors, the metal inserts in the paddles, and the inside of the drum with a soft cloth soaked in vinegar (use white vinegar). See Figure 10.
SELF-HELP Dryers may exhibit problems that are unrelated to a malfunction of the dryer itself. The following table may serve to answer your question about a problem you are having without having to call a serviceman. PROBLEM POSSIBLE CAUSE ‘‘On/Off’’ Indicator light does not come on Dryer does not start The ‘‘On/Off’’ has not been depressed. A fuse may have blown or a circuit breaker tripped. Replace fuse or reset circuit breaker at your fuse box/breaker box.
STATEMENT OF WARRANTIES BOSCH CLOTHES DRYERS The warranties provided by BSH Home Appliances (‘‘Bosch’’) in this Statement of Warranties apply only to Bosch Clothes dryers sold to the first using purchaser by Bosch or its authorized dealers, retailers or service centers in the United States or Canada. The Warranties provided herein are not transferable.
Installation Instruction Introduction Read these installation instructions completely and carefully. They will save you time and effort and help to ensure optimum dryer performance. Be sure to observe all listed warnings and cautions. These installation instructions are intended for use by qualified installers.
# ! $ ! $! Some local codes may require a separate ground. In such cases, the required accessory ground wire, clamp and screw must be purchased separately. Never ground the dryer to plastic plumbing lines, gas lines or water pipes. #! # The receptacle for the dryer cord must be located so that the power supply cord will be accessible when the dryer is in the installed position. # The WTA 3510, electric vented dryer, is intended to be vented to the outdoors.
Technical Data Alcove or Under Counter 23 5/8’’ (600 mm) 22 1/4’’ (565 mm) Sides 0’’ (00 mm) 0’’ (000 mm) Top 0’’ (00 mm) 10’’ (250 mm) Rear 1’’ (25 mm) 5’’ (125 mm) 33 1/2’’ (850 mm) adjusts to 34 1/2’’ (876 mm) Alcove or Under Counter Closet WTA 3510 Ensure air flow of 112 cu.ft./min (3,2 cu.m./min) through dryer Closet door must have 2 (louvered) openings, each having a minimum area of 60 sq. inches (387 sq. cm.
23 5/8’’ (600 mm) minimum DO NOT install the dryer in an area where gasoline or other flammable materials are kept or stored. The dryer must be installed in a room that is adequately ventilated. Make sure there is an adequate supply of fresh air. Both the WTA 3510, electric vented dryer, and the WTL 5410, electric condensation dryer need an adequate supply of fresh air for optimum performance. 23 1/4’’ (590 mm) 33 1/2’’ (850 mm) minimum Figure 13.
INSTALLATION Step 1 Unpack the Dryer Carefully remove the packing material from the outside of the dryer. The duct may be connected to the left, right or back of the WTA 3510, electric vented dryer. If connecting to the left or right hand side of the dryer, remove the sealing cover from the side to be used, as shown in Figure 14. Step 2 Inspect the Dryer Thoroughly inspect the dryer, prior to installation, for possible freight or cosmetic damage.
The connecting piece supplied with your WTA 3510 dryer must then be inserted in the vent opening that will be used. See Figure 16. 12” (30 cm) min. Figure 17. Step 5 Condensate Hose Connection (Model WTL 5410 only!) The WTL 5410 must have its condensate drain line installed and run to a suitable drain. The connection for the condensate hose is located on the back of the WTL 5410, see Figure 18. Figure 16.
Step 6 Electrical The Bosch dryer comes with 4-wire power supply cord pre-installed. This cord fits a 4-wire receptacle as shown in the upper section of Figure 11. If your receptacle is a 3-wire receptacle, as shown in the lower section of Figure 1, a 3-wire ‘‘Dryer Cord’’ must be purchased locally. The 4-wire cord must then be removed and the 3-wire cord installed in its place.
Some local codes may require a separate ground. In such cases, the required accessory ground wire, clamp and screw must be purchased separately. Never ground the dryer to plastic plumbing lines, gas lines or hot water pipes. Step 7 Position and Level the Dryer Place the dryer in position on a clean, level, solidly constructed floor. Installation on any type of carpeting is not recommended. With dryer in position, it must then be leveled.
The dryer should be level with all four feet firmly on the ground. The dryer must not wobble. If the dryer is not level or if it does wobble, the legs must be adjusted. Refer to Figure 22. Adjust the leveling legs until the dryer does not rock and is level, both front-to-back and side-to-side. Step 8 Connect Duct System to Dryer (Model WTA 3510 only!) Connect the exhaust ducting system to the dryer exhaust outlet. Step 9 Final Check List 1.