Installation Manual

5
Prepare Installation Space Prepare Installation Space
Create the cut-out in the countertop according to the
installation diagram. The angle of the cut surface to the
countertop must be 90°.
The lateral cut-out edges must be flat in order to ensure
that the retaining springs are positioned properly on the
appliance. With multi-layered countertops, secure strips
laterally in the cut-out if necessary.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat- and water-resistant manner.
Observe minimum distance between device underside
and cabinet surfaces of
3
/
8
" (10 mm).
The worktop into which the cooktop is installed must be
heat-resistant up to 140° F (90 °C).
The worktop must be reinforced if it is less than
13
/
16
inch
(20 mm) thick.
If the thickness of the worktop into which the cooktop is
installed does not comply with the specifications,
reinforce the worktop using a fire- and water-resistant
material until it reaches the minimum thickness.
Otherwise, sufficient stability cannot be assured.
▯ The worktop into which the cooktop is installed should
withstand loads of approx. 133 lbs (60 kg).
▯ Confirm the cooktop is level only after it has been
installed.
Cutout dimensions for 30" cooktops
Models: NIT5068UC, NIT8069SUC, NIT8069UC,
NITP069SUC, NITP069UC
PLQ




PLQ

[
¡

PLQ
PLQ

PLQ

 PP