User manual

20 | English
1 609 92A 3AY | (3.3.17) Bosch Power Tools
Note: If the machine should automatically switch off because
of a discharged or overheated battery, make sure to set the
machine’s On/Off switch 2 to off. Charge the battery and
allow it to cool down before restarting the machine. Other-
wise the battery can become damaged.
Removing the battery
To remove the battery 3, press the unlocking buttons 4 and
pull the battery out of the machine to the rear. Do not exert
any force.
Battery Charge-control Indication
When the power tool is switched on, the battery charge-
control indicator 6 signals the still available battery capacity
or an overload.
When the battery charge-control indicator 6 flashes red, the
machine is subject to overload. Please observe the infor-
mation in section “Temperature-dependent Overload Protec-
tion”, page 25.
Changing the Tool
 Before any work on the machine itself (e. g. mainte-
nance, tool change, etc.) as well as during transport
and storage, remove the battery from the power tool.
There is danger of injury when unintentionally actuating
the On/Off switch.
 Wear protective gloves when changing application
tools/accessories. Contact with the application tool/
accessory can lead to injuries.
Please observe the application tools/accessories intended
for your tool.
Selecting the Application Tool/Accessory
The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.
Indication Capacity
Continuous lighting, green >70 %
Continuous lighting, yellow 30–70 %
Continuous lighting, red <30 %
Accessory UniversalMulti 12
Accessory Material Application
BIM segment saw
blade
Wooden materials,
Plastic,
Non-ferrous metals
Separating and plunge cuts; also for sawing close to edges,
in corners and hard to reach areas;
example: shortening already installed bottom rails or door
hinges, plunge cuts for adjusting floor panels
Base plate for
sanding, series
Delta 93 mm
Depends on sanding sheet Sanding surfaces close to edges, in corners or hard to reach
areas;
depending on the sanding sheet for, e.g., sanding wood,
paint, varnish, stone
Fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnishes, polishing felt for pre-
polishing
Profile sander
Wood,
Pipes/Profile,
Paint,
Varnishes,
Filler,
Metal
Convenient, efficient sanding of profiles up to a diameter of
55 mm;
Red sanding sheets for sanding wood, pipes/profiles, var-
nishes, fillers and metal
BIM plunge cut
saw blade, wood
and metal
Softwood,
Soft plastics,
Plasterboard,
Thin-walled aluminium
and non-ferrous metal
profiles,
Thin sheet metals,
Non-hardened nails and
screws
Smaller separating and plunge cuts;
example: cutting an opening for sockets, flush cutting a
copper pipe, plunge cuts in plasterboard
Filigree adjustment work in wood;
example: sawing openings for locks and fittings
OBJ_BUCH-2957-001.book Page 20 Friday, March 3, 2017 2:20 PM