User's Guide
Table Of Contents
- 1 Hints for This Document
- 2 Introduction
- 3 General information
- 4 Sets, accessories, mounting material and ordering information
- 5 Functions and configurations
- 6 Activation and coupling of the Connect S2
- 7 Mounting
- 8 Operation and maintenance
- 9 Support
- 10 Technical data
- 11 Handling and transport
- 12 Disposal
- 13 Certifications and regulatory Notes
- 14 Intended Use
- 15 Safety notes
- 16 Third-Party Licenses and Components
Connect S2
| Solar Frame | User Guide
© Robert Bosch Manufacturing Solutions GmbH
Bosch Connected Industry
10 |
39
Accessories: Adhesive set AT-8040
The adhesive set is required for the mounting sets 0 mm – 3 mm and 4 mm – 13 mm.
Order number: 0804.GV5.751
Quantity Product Picture
4 Static mixer
1 Cartridge adhesive AT8040
CAUTION
Observe the information on storage temperature and the expiry date of the adhesive on the
adhesive cartridge.
Store the adhesive cool at the specified temperature.
Do not use the adhesive once the expiry date has passed.
Do not use the adhesive if it is difficult to press it out of the cartridge.
Accessories: Cartridge gun Köratool PM207
The cartridge gun Köratool PM207 is required to press the adhesive out of the cartridges. The tool is reusable.
Order number: 3843.AY0.455
Quantity Product Picture
1 Köratool PM 207
Accessories: Power supply US
The power supply is required for use in countries with US plug and 110 V mains voltage, only for use in the USA and
Canada.
Order number: 3843.AY0.456
Quantity Product Picture
1 AC power supply 110 V (US connector)
2
2
Indoor use only.