User's Guide
Table Of Contents
- 1 Hints for This Document
- 2 Introduction
- 3 General information
- 4 Sets, accessories, mounting material and ordering information
- 5 Functions and configurations
- 6 Activation and coupling of the Connect S2
- 7 Mounting
- 8 Operation and maintenance
- 9 Support
- 10 Technical data
- 11 Handling and transport
- 12 Disposal
- 13 Certifications and regulatory Notes
- 14 Intended Use
- 15 Safety notes
- 16 Third-Party Licenses and Components
Connect S2
| Solar Frame | User Guide
© Robert Bosch Manufacturing Solutions GmbH
Bosch Connected Industry
15 |
39
7 Mounting
Mounting options
Depending on the application, there are various solutions for attaching the Connect S2 to an object.
• Mounting with magnets on stationary metallic objects
• Mounting with M8 screws
• Mounting with Solar Frame, screwed with M5 screws
• Mounting with Solar Frame, glued to surfaces
• Mounting with Solar Frame, glued on the backside
General safety instructions for installation
WARNING
Attaching the device may cause damage to persons or property.
Only use the device if it can be ruled out that the method of attachment will cause damage to
persons or property.
The permanent fixation for the respective application must be ensured. Only use the device if the
method of attachment rules out the possibility of personal injury or damage to property.
Have the installation carried out by qualified personnel only.
CAUTION
The supplied mounting material (nuts, washers, etc.) is used to correctly mount the Solar Frame
and gateway.
Only use the supplied mounting material.
The substrate must be level and must not be heavily soiled so that the Solar Frame rests evenly.
Make sure the surface is flat and clean.
General instructions for installation
TIP
It is recommended to switch on the device before mounting.
Proceed as described in chapter 6, Activation and coupling of the Connect S2.
The radio antennas required for the functions of the Connect S2 are located under the device surface
(below the data matrix code). For optimum function, these antennas must not be covered by metal
objects.