User's Guide
Table Of Contents
- 1 Hints for This Document
- 2 Introduction
- 3 General information
- 4 Sets, accessories, mounting material and ordering information
- 5 Functions and configurations
- 6 Activation and coupling of the Connect S2
- 7 Mounting
- 8 Operation and maintenance
- 9 Support
- 10 Technical data
- 11 Handling and transport
- 12 Disposal
- 13 Certifications and regulatory Notes
- 14 Intended Use
- 15 Safety notes
- 16 Third-Party Licenses and Components
Connect S2
| Solar Frame | User Guide
© Robert Bosch Manufacturing Solutions GmbH
Bosch Connected Industry
16 |
39
Mounting with magnets
No tools are required.
Attach the gateway to a metal surface. Use the two neodymium magnets supplied to attach the gateway.
• Screw the magnets hand-tight completely into the housing
• Carefully attach the device to a metal object with magnets
• Check the device for secure fixing
CAUTION
For safety reasons, attachment with magnets is only permitted up to a maximum height of
2 meters.
Observe the maximum height of 2 m.
Select an alternative mounting method for higher mounting positions.
WARNING
When mounting on vehicles, mobile machines or other moving objects, high accelerations can
affect the device. In these cases, mounting the device with the mounting magnets is not
permitted.
DO NOT attach the gateway to the outside of moving objects such as trucks, trailers, cars or
other vehicles using the magnets.
TIP
When handling the mounting magnets, please also observe the corresponding safety instructions, see
chapter Safety notes at page 34.