User's Guide
Table Of Contents
- 1 Hints for This Document
- 2 Introduction
- 3 General information
- 4 Sets, accessories, mounting material and ordering information
- 5 Functions and configurations
- 6 Activation and coupling of the Connect S2
- 7 Mounting
- 8 Operation and maintenance
- 9 Support
- 10 Technical data
- 11 Handling and transport
- 12 Disposal
- 13 Certifications and regulatory Notes
- 14 Intended Use
- 15 Safety notes
- 16 Third-Party Licenses and Components
Connect S2
| Solar Frame | User Guide
© Robert Bosch Manufacturing Solutions GmbH
Bosch Connected Industry
17 |
39
Mounting with M8 screws
Fasten the gateway at a suitable location using two M8 screws.
For a material thickness of the mounting plate of 1 mm ... 5 mm, the supplied screws can be used. Alternative screws must
be used for material thicknesses of more than 5 mm.
Use the spring washers supplied to secure the screws. Screw the screws from below into the threads provided on the gateway
housing. See the following picture:
Mounting parameters:
Screw tightening torque 5 Nm to 7 Nm
Screw-in depth in the Gateways housing min. 10 mm to max. 14 mm