User's Guide
Table Of Contents
- 1 Hints for This Document
- 2 Introduction
- 3 General information
- 4 Sets, accessories, mounting material and ordering information
- 5 Functions and configurations
- 6 Activation and coupling of the Connect S2
- 7 Mounting
- 8 Operation and maintenance
- 9 Support
- 10 Technical data
- 11 Handling and transport
- 12 Disposal
- 13 Certifications and regulatory Notes
- 14 Intended Use
- 15 Safety notes
- 16 Third-Party Licenses and Components
Connect S2
| Solar Frame | User Guide
© Robert Bosch Manufacturing Solutions GmbH
Bosch Connected Industry
19 |
39
Usage of adhesive AT-8040
CAUTION
Observe the information on storage temperature and the expiry date of the adhesive on the
adhesive cartridge.
Store the adhesive cool at the specified temperature.
Do not use the adhesive once the expiry date has passed.
Do not use the adhesive if it is difficult to press it out of the cartridge.
Step Instruction Picture
1
Insert the 2-K cartridge into the gun Köratool PM 207 and attach the
Köratool static mixer.
2
Clean the surface and the glue studs fastener with Scotchbrite and a
solvent-based cleaner.
3 Apply a small amount of adhesive to the bottom of the glue stud.
4
Press the fixing element firmly onto the substrate until the adhesive
swells out to the sides. Depending on the selected adhesive, the
fastener can be used within 15 to 45 minutes.