User's Guide
Table Of Contents
- 1 Hints for This Document
- 2 Introduction
- 3 General information
- 4 Sets, accessories, mounting material and ordering information
- 5 Functions and configurations
- 6 Activation and coupling of the Connect S2
- 7 Mounting
- 8 Operation and maintenance
- 9 Support
- 10 Technical data
- 11 Handling and transport
- 12 Disposal
- 13 Certifications and regulatory Notes
- 14 Intended Use
- 15 Safety notes
- 16 Third-Party Licenses and Components
Connect S2
| Solar Frame | User Guide
© Robert Bosch Manufacturing Solutions GmbH
Bosch Connected Industry
23 |
39
Mounting with Solar Frame, screwed
INFO
Use screws with a diameter of 5 mm for mounting. The length of the screws must be selected
according to the thickness of the support plate.
Use stainless steel (V2A, V4A) screws suitable for the application and sufficiently strong.
Mounting parameters:
Length of the screws Thickness of carrier plate + 13 mm to 18 mm
Tightening torque of the flange nuts M5 hand-tight
Mounting steps:
1. Mark holes with the help of the Solar Frame
2. Drill holes
3. Activate gateway
4. Connect Solar Frame connector to gateway
5. Insert the gateway into the Solar Frame from below
6. Screws M5 with the length: material thickness + 13 mm to 18 mm
7. Mount the supplied washers
8. Screw the Solar Frame hand-tight with the four flange nuts supplied
9. Check that all four mounting points hold the Solar Frame
10. Close the screw holes with the supplied plugs
Exploded view Rear view Side view