User's Manual
Table Of Contents
- Preliminary Users Manual
- The Electro-Voice (Ev) REV-WT is a Professional Grade Wireless Beltpack
- Transmitter operating in the UHF frequency range. The REV-WT combines frequency agility and ease of use like no other. The transmitter operates within a 24 MHz wide segment in 25 KHz steps.
- The high quality audio circuitry and advanced Radio Frequency (RF) signal
- processing offer broadcast quality signal-to-noise ratio and audio clarity.
- System features include:
- Durable Painted Metal Case.
- TA-4F Audio Connector.
- Permanent Flash Memory for frequency/setting storage.
- On-Loc prevents accidental power off (when set).
REV-WT Users Manual Page 3
Quick set cont’d.
7. Press the Menu button one time to advance to the next screen function.
pressing the button once each time allows the user to scroll through the
functions or change a function.
The next screen is the audio (microphone/instrument) level (attenuator)
screen. Setting the levels correctly depends on the microphone or
instrument used and the person using the microphone. Setting the
attenuator to “0”db is the same as setting a control to maximum gain.
Setting the attenuator to –42 db is the same as setting a control to
minimum gain. Each step of the attenuator equals 3 db.
Setting the attenuator for the maximum Audio Meter reading on the
receiver without peak distortion will produce the best signal to noise
ratio.
8. The next screen is RF Power. The Transmit Power (RF) is shipped set to
“Lo” for use with multiple frequency systems and the best battery life.
“Hi power can be selected for longer distances or to suppress noise or
interference. The nominal power in Hi is 50 milliwatts.
9. The next screen is Voice or Guitar. The transmitter is shipped set to
Voice. To select guitar when in the voice screen, press SET. The
screen will flash, press the Up arrow and the screen will change to
“Gui tAr”. Press SET. The transmitter is now in guitar mode.
To return to Voice (in the “gui tAr”screen) Press SET, the screen flash’s,
press the Down arrow, the screen changes to flashing Voice, Press SET,
flashing stops. The transmitter is now in Voice mode.
10. When power off is required, simply place the power Off-On switch in
the OFF position. The display will then delay slightly to allow the
receiver to shut down quietly.