User's Manual

SET
SYNC
SET
SYNC
①EIA-standard metal 1/2 - rack receiver chassis, antenna diversity.
②The Handheld Transmitter offers durable, ergonomic metal bodies, soft-touch controls.
③Bright and easy-to-read LCD display shows RF/AF, diversity strengths; transmitter battery level;
meanwhile, can set up selective channel, frequency, mute and other working status.
④Press the "AFS"(Auto Frequency Selection) button 3S and the receiver will auto-scan and lock
on to an open, interference-free frequency
⑤Press [IR] button to upload automatically the receiver frequency to the transmitter.
⑥PLL (Phase Lock Loop frequency control) design ensures transmission reliability, "NoiseLock"
squelch effectively blocks stray RF.
⑦Each channel 32 selectable frequencies, dual- channel total 768 selectable frequencies.
⑧Battery life is up to 15 hours.
⑨Designed for use on professional tours, concert halls and houses of worship. Stable functions,
reliable and flexible performance, easy to install.
Introduction
Installation:
①For better operation the receiver should be at least 3ft. 1m above the ground and at least 3ft.
away from a wall or metal surface to minimize reflections.
②Attached a pair of UHF antennas to the antenna input jacks, the antenna are normally positioned in the
shape of a “V” (both 45°from vertical) for best reception.
③Keep antennas away from noise sources such as computer, digital equipment, motors, automobiles
and neon lights, as well as away from large metal objects.
④Keep open space between the receiver and transmitter for better reception.
⑤The transmitter should be at least 3ft. from the receiver.
Connections:
①The switching power supply is designed to operate properly from any AC power source 100-240V,
50/60Hz without user adjustment. Simply connect the receiver to a standard AC power outlet, using only
an IEC-type input cordset approved for the country use. Power to the unit is controlled by the front panel
power switch.
②There are two audio outputs on the rear panel: an XLR microphone output and a 1/4” (6.3mm) phone
jack instrument output. The two isolated audio outputs permit simultaneous feeds to two different
inputs. Use the appropriate shielded audio cable for connections between the receiver and the
input (s) of the mixer or other equipment.
3, Receiver Controls and Functions
( )
Receiver Installation and Connections