User's Manual

Telex TT-16 Transmitter Page 3
Operating Instructions: When the Power button is pressed, the Channel, Frequency, TX power level,
existing audio level settings and intercom type are displayed. After this point, switch functions as
follows:
Operation Function/Result
Press set Channel (“blinks”) flashes.
Press up (arrow) Channel increments.
Press down (arrow) Channel decrements.
Press set Flash stops, Channel is set in memory.
Press set RF Power High flashes
Press up High power
Press down Low power
Press set Flash stops, Level is set in memory. High = displayed, Low = Not displayed
Press set Unbalanced Audio Level flashes.
Press up Audio Level increases at 6 dB per step.
Press down Audio Level decreases at 6 dB per step.
Press set flash stops, Level is set in memory.
Press set Input audio type, RTS 1, RTS 2 or Telx will flash, depending on which
source was last selected. Press set again if the flashing
source item is the desired item or Press up/down button
to select new source. Press set last to save flashing item.
Press set Balanced Audio Level flashes.
Press up Audio Level increases at 6 dB per step.
Press down Audio Level decreases at 6 dB per step.
Press set flash stops, Level is set in memory.
Press set Input audio type, RTS 1, RTS 2 or Telx will flash, depending on which
source was last selected. Press set again if the flashing
source item is the desired item or Press up/down button
to select new source. Press set last to save flashing item.
Special Function Programming
:
E.D.R. : If E.D.R. does not already show on the display and Enhanced Audio
Performance is desired, program as follows:
Press the power switch for 2-3 seconds to remove power, if not already off.
Press and Hold the set button and then Press the power button . E.D.R. should
then be displayed near the MHz Icon. To de-select E.D.R., remove power and
re-apply power while holding the set button in.