Installation Manual

UHI/UHO Series Installation | en 21

Bosch Security Systems User Manual F.01U.026937 | V 2.0 | 2007.01

a. To attach the external safety ground wire, remove the

nut, washers and the external ground wire lug from

the ground post.

b. Strip and crimp the external ground wire into the lug.

c. Reattach the ground connections in the order shown

in Figure 4.7.

Fig. 4.7 Safety grounding

4. Pull any excess wire out of the housing and tighten the fit-

ting to 8.5 Nm to 9.0 Nm (75 inch-lb to 80 inch-lb). This

torque rating is approximately one to one and a half turns

past the point where the fitting starts to grip the wire.

CAUTION!

For compliance with safety regulations, the external ground

wire must always be connected to the main ground post.

Nut

Lock washer

Flat washer

External ground lug

External ground post

NOTE!

Install the external ground in accordance with the NEC/CEC

requirements.