Technical data

English | 15
Bosch Power Tools 1 609 929 M89 | (5.11.07)
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
increase the exposure level over the total work-
ing period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
Technical Data
Declaration of Conformity
We declare under our sole responsibility that the
product described under “Technical Data” is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
18.09.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approx. 5 charging/discharging cycles.
To remove the battery 10 press the unlocking
buttons 9 and pull out the battery downwards.
Do not exert any force.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A long
battery service life is achieved in this manner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Cordless Screwdriver PSR 12 PSR 14,4 PSR 18
Article number
3 603 J55 5.. 3 603 J55 4.. 3 603 J55 3..
Rated voltage
V= 12 14,4 18
No-load speed
rpm 0–700 0–700 0–700
Max. torque for hard/soft screwdriving
application according to ISO 5393
Nm 26/11 28/12 30/13
Max. screw dia.
mm 8 88
Max. drilling dia.
– Steel
–Wood
mm
mm
10
20
10
25
10
28
Weight according to EPTA-Procedure
01/2003
kg 1.4 1.5 1.7
Please observe the article number on the type plate of your machine. The trade names of the individual machines may
vary.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-149-003.book Page 15 Monday, November 5, 2007 10:04 AM