Datasheet

BMA250E
Data sheet
Page 111
BST-BMA250E-DS004-06 | Revision 1.3 | April 2015 Bosch Sensortec
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying and passing on to
third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
Note: Specifications within this document are subject to change without notice.
9.3 Landing Pattern Recommendation
For the design of the landing patterns, we recommend the following dimensioning:
Figure 29: Landing patterns; dimensions are in mm
Same tolerances as given for the outline dimensions (Chapter 9.1, Figure 27) should be
assumed.
A wiring no-go area in the top layer of the PCB below the sensor is strongly recommended (e.g.
no vias, wires or other metal structures).