User Manual

English | 15
Bosch Power Tools F 016 L81 441 | (22.9.16)
Technical Data
Noise/Vibration Information
Mounting and Operation
Starting
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The operating voltage is 230 V AC, 50 Hz (for non-EU coun-
tries 220 V, 240 V as applicable). Only use approved exten-
sion cables. Contact your Bosch Service Centre for details.
If you want to use an extension cable when operating your
high pressure washer, only the following cable dimensions
should be used:
– 1.5 mm
2
– max length 20 m
– 2.5 mm
2
– max length 50 m
Pressure washer AQT 35-12/
AQT 35-12+
AQT 37-13/
AQT 37-13+
AQT 40-13
Article number
3 600 HA7 1.. 3 600 HA7 2.. 3 600 HA7 5..
Rated power
kW 1.5 1.7 1.9
Supply temperature max.
°C 40 40 40
Supply rate min.
l/min 5.8 6.2 6.6
Allowable pressure
MPa 12 13 13
Rated pressure
MPa 8 99
Rated Flow
l/min 5 5.5 6
Maximum inlet pressure
MPa 1 11
Autostop function
 
Weight according to EPTA-Procedure 01:2014
kg 6.65/8.12 7.83/8.82 8.9
Protection class
/II /II /II
Serial number
See serial number (rating plate) on pressure washer.
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Starting cycles generate brief voltage drops. Interference with other equipment/machines may occur in case of unfavourable mains system conditions.
Malfunctions are not to be expected for system impedances below 0.153 ohm.
Sound emission values determined according to EN 60335-2-79. 3 600 ... HA7 1.. HA7 2.. HA7 5..
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
dB(A)
dB(A)
dB
83
93
2
78
90
1
83
94
2
Vibration total values a
h
(triax vector sum) and uncertainty K determined
according to EN 60335-2-79:
Vibration emission value a
h
Uncertainty K
m/s
2
m/s
2
=7
=2
=2
=2
=4,7
=1.5
Action Figure Page
Delivery Scope
1 259–260
Fold down handle operation
2 261
Connecting high pressure gun to lance
3 262
Connecting high pressure water supply
hose/nozzle
4 262
Attaching Nozzles
5 263–265
Connecting to the water supply
6 265
Switching On and Off
7 266
Adjust water jet
8 266
Connect detergent bottle
9 267
Clean the water filter
10 267
Clean nozzle
11 268
Gun storage
12 268
Gun/lance/nozzle is stored in action
13 269
Hose into the hose holder 14 269
Storage
15 269
Selecting Accessories
16 270
Action Figure Page
OBJ_BUCH-1953-009.book Page 15 Thursday, September 22, 2016 12:11 PM