Instructions Manual and Use and Care

en-us
21
2. Press a glass or container against the dispenser
lever until the glass is filled with the desired amount
of water.
Note:
The water from the water dispenser is cooled to a
pleasant temperature for drinking. If you prefer the
water to be colder, dispense some ice cubes into the
glass before drawing the water.
Dispensing ice
Only hold the container against the dispenser lever until
the container is half full of ice. Otherwise, the ice in the
ice-cube dispenser spout may cause the container to
overflow or block the ice cube dispenser spout.
If crushed ice was dispensed before dispensing ice
cubes, there may still be some crushed ice in the
dispenser spout. It will come out together with the first
few ice cubes.
1. Press the "Ice cubes/Crushed ice" button until the
display shows the "Ice cubes" or "Crushed ice"
symbol.
2. Press a suitable glass or container against the
dispenser lever until it is filled with the desired
amount of ice.
Switching off the ice-maker
Note:
It is imperative to turn off the water supply to the
appliance several hours before switching off the
ice-maker.
If you do not expect to be using the ice-maker for
longer than 1 week (e.g. when going on holiday), the
ice-maker should be temporarily switched off to stop
the ice cubes freezing together.
1. Press and hold the "Ice cubes/Crushed ice" button
for 3 seconds.
In the display, the symbols "Ice cubes", "Crushed ice"
and "Lock" flash for approx. 3 seconds.
Then the water dispensing is switched on and the
symbol "Water" lights up.
Note:
When the "Ice cubes/Crushed ice" button is pressed,
when the ice-maker is switched off, an alarm sounds
and the symbols "Ice cubes" , "Crushed ice" and "Lock"
flash for approx. 3 seconds.