Instructions Manual and Use and Care

en-us
7
Subsurface
Weight of appliance when empty:
Wall clearance
If the appliance is positioned in the corner of a room or
a recess, minimum clearances (see section ”Installation
dimensions”) at the sides must be maintained so that
the appliance doors can be fully opened.
If the depth of the adjacent kitchen fittings exceeds
25.6” (65 cm), minimum clearances at the sides must
be maintained so that the full opening width of the
doors can be utilized (see section ”Door opening
angle”).
Minimum clearance at rear
Fix the spacers supplied to the holes provided on the
rear of the appliance using the screws.
Important:
The spacers maintain the minimum clearance of
2” (50 mm) from the wall, thus providing adequate
ventilation.
Observe the room temperature and
ventilation requirements
Room temperature
The appliance is designed for a certain climate class.
Depending on the climate class, the appliance can be
operated at the following ambient temperatures.
The climate class is specified on the rating plate.
Note:
The appliance is fully functional within the room
temperature limits of the specified climate class. If an
appliance in the SN climate class is operated at lower
ambient temperatures, damage to the appliance can be
excluded up to a temperature of 41 °F (+5 °C).
Ventilation
The heated air must be able to escape unimpeded.
Otherwise, the refrigerating unit has to work harder,
which increases the appliance's power consumption.
Therefore, never cover over or block the air vent.
NOTICE
The appliance is very heavy.
The floor on which the appliance is to be installed
must be rigid. Reinforce the floor, if necessary.
Basic model 245 lb (111 kg)
Climatic class Permitted ambient temperature
SN 50 °F to 90 °F (+10 °C to 32 °C)
N 61 °F to 90 °F (+16 °C to 32 °C)
ST 61 °F to 100 °F (+16 °C to 38 °C)
T 61 °F to 110 °F (+16 °C to 43 °C)