Instruction manual

COMMISSIONING PROCEDURE GREENSTORE
6 720 806 768 (2013/02) 69
26 COMMISSIONING PROCEDURE GREENSTORE
Customer/responsible for installation:
Installer of installation:
Heat pump type: Serial number:
Commissioning date: Date of manufacture:
Type of collector: Total length of collector:
Other components in the installation:
Additional heat  Room controller T5 
Water heater  Exhaust air collector 
3-way valve  Hot water sensor T3 
Flow line sensor heating circuit 2 E12.T1 
Miscellaneous:
The following work has been carried out:
Heating system: filled  vented  particle filter cleaned  minimum flow ensured installation of T1 checked  Heat curve set 
Collector system: filled  vented  particle filter cleaned  vents installed  collector fluid concentration checked 
Electrical connection: performed  motor cut-out settings checked 
Sight glass: checked  notes:
Operating temperatures after 10 minutes heating/hot water operation:
Heat transfer fluid out (T8):.................. °C Heat transfer fluid in (T9):................ °C
Temperature difference between Heat transfer fluid out (T8) and in (T9) approx. 6 ... 10 K ( °C) 
Collector circuit in (T10): .................. °C Collector circuit out (T11): .................. °C
Temperature difference between Collector circuit in (T10) and Collector circuit out (T11) approx. 2 ... 5 K ( °C) 
Setting heat carrier pump (G2): Setting collector circuit pump (G3):
Leak test for heating system and collector system carried out 
Function check carried out 
Customer/responsible for installation: has been informed of how to operate the heat pump 
Documentation handed over 
Date and signature of installation installer:
Table 182