User Manual

581618 | REV. B | 11.2018
Bosch Automotive Service Solutions Inc.
HDS 200/HDS 250
HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles
|
User guide | 17
|
en
• If there is not a checkmark next to the item, then
this item can’t be selected until the appropriate
function is run from the Heavy Duty Standard
menu, HD OBD menu or Global Automotive
OBDII menu.
• Only one function, Recording, needs detailed
instructions.
Review Data
✓I/M Monitors
✓DTCs (Codes)
✓State OBD Check
✓Recording
View Freeze Data
✓O2 Monitor Tests
✓Diagnostic Monitor Tests
Vehicle Information
Modules Present
Recording
The Recording function is used to play back a recording.
This function is very similar to View Data. The only differ-
ence is that View Data is real-time viewing of PIDs, while
Recording is a viewing of previously recorded PIDs.
From the Review Data menu:
1. Select Recording.
• Use the UP and DOWN keys until Record-
ing is highlighted.
• The tool can keep up to 5 recordings per vehi-
cle. If the tool has more than one recording,
select the recording you wish to playback.
• Press .
2. Select Playback Recording.
• Use the UP and DOWN keys until Playback
Recording is highlighted.
• Press .
Playback Options
Playback Recording
Long PID/SPN Names
English/Metric
• The recording has frame number and timestamp
(in seconds).
– Negative frames and timestamps indicate
data recorded before trigger event.
– Positive frames and timestamps indicate
data recorded after trigger event.
– Use the UP and DOWN keys to view
recorded PID data within each frame.
– Use the LEFT and RIGHT keys to scroll
back and forth through frames.
– Refer to “8 Appendix A—Global OBD II PID
Definitions” on page 42.
– Refer to “9 Appendix B—Glossary” on page
45 for HD abbreviations.
ABSLT TPS(%)
CALC LOAD(%)
COOLANT(°F)
ENG SPEED(RPM)
FUEL SYS 1
FUEL SYS 2
IAT(°F)
IGN ADV(°)
LT FTRM1(%)
0.0
3.5
95
692
OPEN
OPEN
75
4.5
3.1
Frame:
Throttle position
Time: 0.00
– If graphing is available for selected PID, the
“ ” icon is located on the side of the
screen.
• Press to select PIDS to graph.
– Use the UP and DOWN keys to high-
light the second PID to graph and then
press the RIGHT key to select. A maxi-
mum of two PIDs can be graphed. Press
to see graph.
Select PIDs to Graph
ABSLT TPS(%)
✓CALC LOAD(%)
COOLANT(°F)
ENG SPEED(RPM)
IAT(°F)
MAF(LB/M)
MAP(”HG)
VEH SPEED(MPH)
Calculated Engine Load
• The triangle below the graph indicates the
position of the frame in the graph.
– Use the LEFT and RIGHT keys to scroll
back and forth through graph.
– Use the UP and DOWN keys to toggle
back and forth between PIDs.
CALC LOAD(%)
19.4
17.5
Frame: Time:
21 26.8
19.2
• Different vehicles communicate at different
speeds and support a different number of PIDs.
Therefore, the maximum number of frames that
can be recorded varies.
3. Return to Review Data menu.