User Manual

581618 | REV. B | 11.2018
Bosch Automotive Service Solutions Inc.
HDS 200/HDS 250
HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles
|
User guide | 19
|
en
Emissions Control Information decal located under the
vehicles hood.
From the Main Menu:
1. Select HD SAE (J1708/J1587, J1939), HD OBD
(ISO 15765-4) or Global Automotive OBDII.
• Use the UP and DOWN keys until HD SAE
(J1708/J1587, J1939) is highlighted.
• Press .
Main Menu
HD SAE (J1708/J1587, J1939)
HD OBD (ISO 15765-4)
Global Automotive OBDII
Review Data
Print Data
System Setup
2. Use the LEFT and RIGHT keys to select Yes.
• The scan tool keeps diagnostic data for only
the last vehicle. This data is cleared by select-
ing Yes.
• Press .
Heavy Duty Standard
This selection requires
clearing of diagnostic data
for the previous vehicle.
Do you want to continue?
No
Yes
3. Make sure the proper diagnostic cable is connected
per screen instructions.
• Confirm proper scan tool cable part number is
connected.
• Press F1 to toggle Demo mode on or off.
• Press .
IMPORTANT
To display demonstration data, press the
F1 key. A checkmark in the demo
button indicates Demo function is on.
Press the key again to turn the function
off. When in demo mode, the scan tool
doesn’t communicate with a vehicle but
will instead display demonstration data.
4. A Turn Key Off screen will display.
Turn Key Off
Press ENTER to continue
Please turn the key off for
10 seconds then turn the key
on.
• Turn key off for 10 seconds.
• Turn key on.
• Press .
• If vehicle power is not detected, a screen is
shown to verify tool connection (non-demo
mode).
Vehicle Required
Press ENTER to continue
Please verify the tool is
connected to the vehicle with
the ignition key turned on.
5 Heavy Duty Standard Diag-
nostics
Heavy Duty Standard Diagnostics is available by select-
ing Heavy Duty Standard from the Main Menu. This
section applies to all heavy duty SAE J1708/J1587 &
J1939 compliant vehicles.
The first time the scan tool links to the vehicle, the
communication protocol is automatically detected, and
is used until the scan tool is turned off or another vehi-
cle is diagnosed.
If an error message displays, make sure the scan tool
connector is attached and the ignition key is on. Cycle
ignition key to OFF for 10 seconds, then ON. This may be
required to reset computer. If required, select YES to try
again. If problem still exists, “7.1 Error Messages” on
page 41.
The scan tool keeps data received from the previous
vehicle selected until any of the following occurs:
• A new vehicle is selected.
• Scan tool is flash programmed to update software.
The Heavy Duty Standard Menu has the following selec-
tions:
• Read Codes
• Erase Codes
• View Data
• Record Data
• Module Information