User Manual

581618 | REV. B | 11.2018
Bosch Automotive Service Solutions Inc.
HDS 200/HDS 250
HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles
|
User guide | 21
|
en
In this example, the J1587 Engine #1 module, Module
Identifier (MID) 128 is reporting a DTC. It was Active at
the time DTCs were read.
Injector Cylinder #6 - Data erratic,
intermittent, or incorrect
ACTIVE
1/6
MID: 128
SID:6
FMI:2
EraseLamp Status
Engine #1
In this example, the J1939 Engine #1 module, Source
Address (SA) 0 is reporting a DTC. It was Active at the
time DTCs were read. This specific SPN/FMI has only
occurred one time.
Accelerator Pedal Position 1 - Voltage
Below Normal, Or Shorted To Low Source
Count: 1ACTIVE
1/23
SA: 0
SID:91
FMI:4
EraseLamp Status
Engine #1
Lamp Status
Press the F1 key while viewing a DTC to show the
Lamp status for the module of the given DTC. Details of
all possible Lamps is shown.
Lamp Status
MIL:
Red Stop:
Amber Warning:
Protect:
Unavailable
On
Off
Off
To return to the last DTC being reviewed, press .
Erase
Press the F2 key while viewing a DTC to jump to the
Erase Codes screen. The distinction between erasing
codes by pressing F2 from Read Codes or selecting
Erase Codes from the Heavy Duty Standard menu is
that you can erase a specific DTC when starting from
Read Codes. The DTC shown when the F2 key is pressed
can be erased. See “5.2 Erase Codes” on page 21.
5.2 Erase Codes
The Erase Codes function deletes DTCs from vehicle’s
control module(s). Perform this function key on engine
off (KOEO). Do not start the engine.
The Erase Codes function may also erase diagnostic
information pertaining to the specified DTC. Perform
Erase Codes function only after systems have been
checked completely and DTCs have been written down.
After servicing the vehicle, erase stored DTCs and verify
no codes have returned. If a DTC returns, problem has
not been fixed or other faults are present.
From Heavy Duty Standard menu:
1. a. Select Erase Codes.
• Use the UP and DOWN keys until Erase
Codes is highlighted.
• Press .
Heavy Duty Standard
Read Codes
Erase Codes
View Data
Record Data
Module Information
Vehicle Information
Review Data
Print Data
System Setup
OR
From Read Codes DTC Description screen:
1. b. Press F2, Erase.
Accelerator Pedal Position 1 - Voltage
Below Normal, Or Shorted To Low Source
Count: 1ACTIVE
1/23
SA: 0
SID:91
FMI:4
EraseLamp Status
Engine #1
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No
Yes
2. Select YES to erase diagnostic results and codes.
• Use the LEFT arrow key.
• Press .
• If diagnostic results and codes are not to be
erased select NO and press .