User Manual
Table Of Contents
- 1 Safety Precautions
- 1.1 Read All Instructions
- 2 Important Safety Warnings and Instructions
- 3 Getting Started
- 4 Using the Scan Tool
- 5 Heavy Duty Standard Diagnostics
- 6 OBD II Diagnostics
- 7 Troubleshooting
- 8 Appendix A—Global OBD II PID Definitions
- 9 Appendix B—Glossary
- 10 Third Party Licenses
- 11 Limited Warranty
en
|
26
|
User guide
| HDS 200/HDS 250
HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles
581618 | REV. B | 11.2018
Bosch Automotive Service Solutions Inc.
Recording
Press ENTER to trigger
recording
Collecting pretrigger data
Recording
Press ENTER to end recording
Collecting data for frame #4
7. After recording, scan tool displays a prompt to
Playback Data.
• Select NO to return to Heavy Duty Standard
menu.
• Select YES to display recorded data.
• Refer to”Recording” on page 17 for instruc-
tions on how to play back data.
Record Data
Playback data?
No
Yes
5.5 Module Information
The Module Information function allows the scan tool to
request information from modules on the vehicle. Infor-
mation collected includes Make, Module, Serial Number,
Power Unit, ECU Part Number, ECU Serial Number, ECU
Location, ECU Type, ECU Manufacturer Name, ECU
Hardware ID, Software Identifier, CVN ID, Calibration ID,
Vehicle Distance, Trip Distance, Total Vehicle Hours, &
VIN. A typical module may support some but not all of
this information.
The scan tool cannot verify if data is correct for scanned
modules.
From Heavy Duty Standard menu:
1. Select Module Information.
• Use the UP and DOWN keys until Module
Information is highlighted.
• Press .
Heavy Duty Standard
Read Codes
Module Information
View Data
Record Data
Erase Codes
Vehicle Information
Review Data
Print Data
System Setup
2. A module menu is displayed.
• Use the UP and DOWN keys until the
designed choice is highlighted.
• The menu is divided into two sections, a J1587
Module section and a J1939 Module section.
• The bottom line displays information for the
highlighted module: Protocol, module address
(Module Identifier=MID and Source Address =
SA) and full module description.
Select Module
J1587 MID: 128 Engine #1
Transmission
Engine #1
J1939 Modules
Engine #1
Transmission #1
J1587 Modules
All Listed Modules
3. View information supported by vehicle.
• Use the UP and DOWN keys (if required).
In this example, the Brake, Power Unit module returned
data.
Module Information
Brakes, Power Unit
**BNDWS
Model
EC-30 JI
Serial Number
F43080
Software ID
Make
BW-362-CD R07
In this example, the Engine #1 module returned data.
Use the UP and DOWN keys to view all the infor-
mation.