User Manual

581618 | REV. B | 11.2018
Bosch Automotive Service Solutions Inc.
HDS 200/HDS 250
HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles
|
User guide | 27
|
en
Module Information
Engine #1
INT
Model
390224241011696M10 CARB ESS
EXEMPT
Serial Number
6.5HM2Y5303951 *
VIN
Make
1HTJTSKL6BH449799
Module Information
Engine #1
CVN Calibration ID
67820293
Software ID
Serial Number
6.5HM2Y5303951 *
VIN
Calibration Information
1HTJTSKL6BH449799
PRS29XR5
4. Return to Module Information menu.
• Press .
5. Return to Heavy Duty Standard menu.
• Press .
5.6 Vehicle Information
The Vehicle Information function allows the scan tool to
request information from the Engine module(s) on the
vehicle. Information collected includes Total Vehicle
Distance, Total Vehicle Hours, & VIN.
The scan tool cannot verify if data is correct for scanned
modules.
From Heavy Duty Standard menu:
1. Select Vehicle Information.
• Use the UP and DOWN keys until Vehicle
Information is highlighted.
• Press .
Heavy Duty Standard
Read Codes
Vehicle Information
View Data
Record Data
Erase Codes
Module Information
Review Data
Print Data
System Setup
2. View information supported by vehicle.
Vehicle Information
3FRWF6FC4BV629240
Total Distance
144983 Miles/233328 km
VIN
Total Time (h:mm)
2414:00
3. Return to Heavy Duty Standard menu.
• Press .
6 OBD II Diagnostics
OBDII Diagnostics is available by selecting HD OBD (ISO
15765-4) or Global Automotive OBDII from the Main
Menu.
This section applies to all Global OBD II compliant vehi-
cles. The first time the scan tool links to the vehicle, the
communication protocol is automatically detected, and
is used until the scan tool is turned off or another vehi-
cle is diagnosed.
If an error message displays, make sure the OBD II
connector is attached and the ignition key is on. Cycle
ignition key to OFF for 10 seconds, then ON. This may be
required to reset computer. If required, select YES to try
again. If problem still exists, refer to “7.1 Error Mes-
sages” on page 41.
The scan tool keeps data received from the previous
vehicle selected until any of the following occurs:
• A new vehicle is selected.
• Scan tool is flash programmed to update software.
On initial link to vehicle, scan tool checks the status of
I/M Monitors no matter which function is selected.
IMPORTANT
Review Data, Print Data, and System
Setup are covered in Section 5 of this
manual. These items are not covered in
this section.
The HD OBD menu and Global Automotive OBDII menu
are broken down into the following selections:
• I/M Monitors
• Read Codes
• Erase Codes
• MIL Status
• State OBD Check
• View Data
• Record Data
• View Freeze Data
• Drive Cycle Monitor
• O2 Monitor Tests
• Diagnostic Monitor Tests
• On-Board Systems
• Vehicle Information
• Modules Present