User Manual
Table Of Contents
- 1 Safety Precautions
- 1.1 Read All Instructions
- 2 Important Safety Warnings and Instructions
- 3 Getting Started
- 4 Using the Scan Tool
- 5 Heavy Duty Standard Diagnostics
- 6 OBD II Diagnostics
- 7 Troubleshooting
- 8 Appendix A—Global OBD II PID Definitions
- 9 Appendix B—Glossary
- 10 Third Party Licenses
- 11 Limited Warranty
en
|
34
|
User guide
| HDS 200/HDS 250
HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles
581618 | REV. B | 11.2018
Bosch Automotive Service Solutions Inc.
6. Return to HD OBD menu or Global Automotive
OBDII menu.
• Press .
6.7 Record Data
The Record Data function records PIDs while vehicle is
parked or being driven. The Record Data function is
mainly used for diagnosing intermittent driveability
problems that cannot be isolated by any other method.
The recording time varies. A recording consists of frames
of data before the trigger and several frames after the
trigger.
CAUTION
Two people must be in vehicle when driv-
ing. One to drive and the other to operate
the scan tool.
From HD OBD menu or Global Automotive OBDII menu:
1. Select Record Data.
• Use the UP and DOWN keys until Record
Data is highlighted.
• Press .
Global Automotive OBDII
Read Codes
Record Data
Erase Codes
View Data
MIL Status
State OBD Check
View Freeze Data
Drive Cycle Monitor
I/M Monitors
2. Follow all instructions on display.
• The scan tool can maintain 5 recordings per
vehicle. If there are already 5 recordings stored,
the scan tool will ask which recording to over-
write.
• Scan tool validates list of global PIDs from
vehicle.
Validating PIDs
Please Wait
Validating PID List
PID 116/329
3. Refer to”6.6 View Data” on page 31 to setup
Custom List or View Entire List and Pre-Trigger
Setup to set the number of frames to keep prior to
triggering the recording.
Select Data to Record
Entire Data List
Custom Data List
Pre-Trigger Setup
4. Press to begin recording.
• Data continues to be saved until either:
– Record memory is full.
– Operator presses .
• Scan tool recording times vary. A recording
consists of frames of data before trigger and
several frames after trigger.
Recording
Press ENTER to trigger
recording
Collecting pretrigger data
Recording
Press ENTER to end recording
Collecting data for frame #4
5. After recording, scan tool displays a prompt to
Playback Data.
• Select NO to return to Datastream Menu.
• Select YES to display recorded data.
• Refer to”Recording” on page 17 for instruc-
tions on how to play back data.
Record Data
Playback data?
No
Yes