User Manual

en
|
38
|
User guide
| HDS 200/HDS 250
HD Scan Tool for Class 4-8 Diesel, Light and Medium Vehicles
581618 | REV. B | 11.2018
Bosch Automotive Service Solutions Inc.
CAN Vehicles
Select Diag Mon Test
O2 Sensor B1S1
O2 Sensor B1S2
O2 Sensor B2S1
O2 Sensor B2S2
Catalyst B1
Catalyst B2
EGR Mon B1
EVAP (0.090”)
EVAP (0.020”)
On Non-CAN vehicles the scan tool displays:
– Test data (test ID)
– Maximum value (MAX)
– Test measurements (MEAS)
– Minimum value (MIN)
– Status (STS)
– Measurements and Specification values are
hexadecimal numbers (i.e., $1A, $FE, $11.)
– Module (MOD)
Test $03
ID
MOD
MAX
MEAS
MIN
STS
01
$09
----
00
00
OK
• On CAN vehicles scan tool displays:
– Test performed. The test performed can be
$## if test is not defined. Refer to vehicle
service manual for details.
– Measured values and units of measured
(such as volts, amps, and seconds).
– Status of monitor test data.
– Module ID where the monitor test data
came from.
O2 Sensor B1S1
RICH-LN Thresh
MOD
MAX
MEAS
MIN
STS
$07
0.4497(V)
0.4497(V)
0.4497(V)
OK
3. Return to Select Test menu.
• Press .
4. Return to Special Tests Menu.
• Press .
6.12 On-Board Systems
The On-Board Systems test allows the scan tool to
control operation of vehicle components, tests or sys-
tems.
• Some manufacturers do not allow tools to control
vehicle systems. A vehicle not supporting an on-
board system is identified by a message that is
displayed when selected.
• Refer to the vehicle service manual for on-board
systems instructions.
• The manufacturer is responsible for determining the
criteria to automatically stop test. Refer to appropri-
ate vehicle service manual.
From HD OBD menu or Global Automotive OBDII menu:
1. Select On-Board Systems.
• Use the UP and DOWN keys until On-
Board Systems is highlighted.
• Press .
Global Automotive OBDII
O2 Monitor Tests
On-Board Systems
Diagnostic Monitor Tests
Review Data
Vehicle Information
Modules Present
Print Data
System Setup
Drive Cycle Monitor
• A list of on-board systems and components
available for testing are shown on the display.
2. Select test.
• Use the UP and DOWN keys until desired
test is highlighted.
• Press .
On-Board Systems
EVAP System Test
On-Board Systems
Press ENTER to continue
Command sent
3. Return to On-Board Systems menu.