Instruction manual

English | 7
Bosch Power Tools F 016 L81 065 | (28.1.14)
Battery charge-control indication
The battery charge-control indicator on the handle of the
product will indicate a low charge condition of the battery by
flashing three times when the On/Off switch is pressed. If this
occurs, please remove the battery and recharge.
Charging Procedure
The charging procedure starts as soon as the mains plug is
plugged into the socket and the battery is then inserted into
the battery charger .
Due to the intelligent charging method, the charging condi-
tion of the battery is automatically detected and the battery is
charged with the optimum charging current, depending on
battery temperature and voltage.
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
Note: The charging procedure is only possible when the bat-
tery temperature is within the allowable charging tempera-
ture range, see section “Technical Data”.
Flashing Battery Charge Indicator
The charging procedure is signalled by a
flashing battery charge indicator .
Continuous Lighting of the Battery Charge Indica-
tor
Continuous lighting of the battery
charge indicator indicates that the
battery is fully charged or that the
temperature of the battery is not with-
in the allowable charging temperature range, and cannot be
charged for this reason. The battery is charged as soon as the
allowable charging temperature range is reached.
When the battery is not inserted, continuous lighting of the
battery charge indicator indicates that the mains plug is in-
serted in the socket and that the battery charger is ready for
operation.
Charging Advice
With continuous or several repetitive charging cycles without
interruption, the charger can warm up. This is not meaningful
and does not indicate a technical defect of the battery charg-
er.
A significantly reduced working period after charging indi-
cates that the battery is used and must be replaced.
Troubleshooting
After-sales Service and Application
Service
www.bosch-garden.com
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the garden product.
d.c.
Problem Possible Cause Corrective Action
Blade guard can not be mounted over
cutting disc
Incorrect assembly Remove cutting disc and mount blade
guard again
Trimmer fails to operate Battery discharged Recharge battery; also see “Battery
Charging”
Battery too hot/cold Allow to cool/warm
Trimmer runs intermittently Internal wiring of garden product dam-
aged
Contact Service Agent
On/Off switch defective Contact Service Agent
Garden product labours Grass too high Cut in stages
Garden product does not cut Cutting blade damaged Replace the blade
Increased vibration Cutting blade damaged Replace the blade
OBJ_BUCH-2106-002.book Page 7 Tuesday, January 28, 2014 2:13 PM