User Manual

22
Environmental protection/Recycling
Tronic 1000 T – 6 720 821 421 (2017/10)
“Safety”. The change of anode must be done by a plumber or
authorised service person.
Corrosive Water
Water deemed to be corrosive can attack parts causing them to
fail. When the water supply Saturation Index (check with your
local water supplier for additional information) is less than -
1.0, water is deemed corrosive and a corrosion resistant
heating element should be used. The effect of scaling water is
the build up of calcium carbonate onto hot metallic surfaces.
When the Saturation Index is greater than +0.40, an expansion
control valve must be fitted on the cold water line after the non-
return valve. Should the Saturation Index exceed +0.80, a low-
watts density heating element should be fitted to your water
heater by your local Bosch authorised service agent.
Water quality table
Maximum levels:
12 Environmental protection/Recycling
Environmental protection is one of the fundamental company
policies of the Bosch Group.
Product quality, efficiency, and environmental protection are
equally important objectives for us. We comply with all
environmental protection laws and regulations.
In order to protect the environment, we use the latest
technologies and the best materials whilst bearing in mind the
economic implications.
Packaging
Where packaging is concerned, we participate in the relevant
local recycling systems in order to ensure optimum recycling.
All of our packaging materials are environmentally friendly and
can be reused.
13 Warranty details
Robert Bosch (Australia) Pty Ltd
Thermotechnology Division
Voluntary Repair or Replacement Warranty
All Bosch products are carefully checked, tested and certified
to Australian and New Zealand standards.
Important Note: Mandatory Australian Consumer Law
statement
If you have purchased your product in Australia, you should be
aware that:
This warranty is provided in addition to other rights and
remedies held by a consumer at law. Our goods come with
guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for
a major failure, and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
Important Note: New Zealand law
If you have purchased your product in New Zealand, you should
be aware that:
This warranty is supplemental to any other rights and remedies
you have under the Consumer Guarantees Act 1993 NZ, unless
your purchase is made for commercial purposes, in which case
Bosch excludes all consumer guarantees implied in the
Consumer Guarantees Act 1993 NZ in respect of your product.
Warranty
Bosch warrants, at its option, to repair or replace your water
heater or relevant part thereof (Product) if such Products are
faulty or defective in manufacture or materials during the
warranty period specified below.
The warranty period commences on the date of purchase. If the
date of original purchase cannot be determined, then the
warranty period will commence six (6) months after the date of
manufacture stamped on the Product.
Bosch may require evidence to verify the date of purchase.
This warranty only covers repair or replacement of defective
Product (including labour costs where indicated). It does not
cover:
• any costs incurred by the end user in normal or scheduled
maintenance of the Product; or
• subject to any law to the contrary, any damage to property,
personal injury, direct or indirect loss, consequential
losses or other expenses arising from breach of this
warranty. Any end user concerned with this exclusion
pH Saturation
Index(LSI)
(langelier)
Total
Hardness
Chlorides Sodium Iron
6.5-9.0 +0.4 to -1.0
at 65 °C
200
mg/l
250
mg/l
180
mg/l
1
mg/l
Table 6