Install Instructions
Table Of Contents
- Table of contents
- 1 Key to symbols and safety instructions
- 1.1 Key to symbols
- 1.2 Safety precautions
- 2 Information about the heater
- 3 Regulations
- 4 Installation
- 5 Operation instructions
- 6 Maintenance
- 7 Service
- 8 Troubleshooting
- 9 Spare Parts
- 10 Environment / disposal
- Indice
- 1 Explicación de la simbología y instrucciones de seguridad
- 1.1 Explicación de los símbolos
- 1.2 Instrucciones Importantes de Seguridad
- 2 Información sobre el calentador
- 3 Reglamentos
- 4 Instalación
- 5 Instrucciones de funcionamiento
- 6 Mantenimiento
- 7 Problemas
- 8 Piezas de repuesto
- 9 Protección del medio ambiente/reciclaje
- Sommaire
- 1 Explication des symboles et mesures de sécurité
- 1.1 Explication des symboles
- 1.2 Importantes instructions de sécurité
- 2 Informations relatives au chauffe- eau
- 3 Règlementations
- 4 Installation
- 5 Instructions d'utilisation
- 6 Maintenance
- 7 Diagnostic de pannes
- 8 Liste des pièces de rechange
- 9 Protection de l’environnement/ Recyclage
6 720 647 022 (2014/06)Tronic 5000C
Installation | 9
4.2.2 Recomended minimum clearances for servicing
Should it be necessary to service the Tronic 5000C Pro,
observe the following clearances. These are not required
clearances, but would facilitate any service work.
Fig. 4 Recommended minimum clearances
4.3 Mounting the water heater
▶ Undo the retaining screws on the front cover and take the
cover off the heater. Hold the back plate in position against
the wall and mark the four mounting holes.
▶ Drill the holes and secure the heater using the four wood
screws supplied.
Fig. 5 Vertical mounting position
WH36
Top (A) 12”
Sides 0”
Bottom (B) 6”
Front (C) 12”
Table 6 Recommended minimum clearances
WARNING:
▶ The heater must only be installed in the
orientation shown in Fig. 5 i.e., mounted
in a vertical position with the water
fittings located at the bottom of the
heater. Under no circumstances
should the heater be mounted
differently.