Installation Guide

6 720 810 559 (2016/06)OptiFlow Professional
Electrical connection (only by authorised technicians) | 13
4.7 Remote control connection (optional)
Connecting the communication cable to the remote control
▶ Open the remote control.
▶ Remove the larger connector from the communication
cable.
▶ Connect the larger connector to the controller in the
position shown in Fig. 7.
▶ Remove the plastic tag to allow the cable to be feed
through.
▶ Feed the end of the cable without a connector through the
opening in the back cover.
▶ Reconnect the cable to the larger connector.
▶ Refit the front and back covers back together.
▶ Close the remote control.
Fig. 6
[1] Remote control front cover
[2] Remote control back cover
[3] Communication cable
Connecting the communication cable to the appliance
▶ Connect the communication cable to the appliance.
Fig. 7
The remote control connection is concluded.
5 Electrical connection (only by authorised
technicians)
All the regulating, control and safety devices in the appliance
are factory supplied already connected and ready to operate.
5.1 Connecting the power cable
2
1
1.
6720806426-03.1V
3
DANGER: Due to electric shock!
▶ Before carrying out work on electrical
components, disconnect the power
supply (230 V AC) (fuse, circuit
breaker) and secure against
unintentional reconnection.
CAUTION: Electrical storm!
▶ The appliance must have an
independent connection in the electric
box, protected by a differential safety
switch of 30 mA and ground line. In areas
with frequent electrical storms, a
protector against electrical storms must
also be fitted.
The electrical connection must be done in
accordance with AS/NZS3000.
1.
6720808877-04.1V