Gas Conversion Kit Manual

6 720 607 679
Gas Type Conversion
3
B. Converting from LPG to NG
B 1. Add jumper to location JP6 on the control board
(Fig. 4).
Fig. 4
B 2. Turn slotted brass screw 3.5 turns counter
clockwise (Fig. 2).
B 3. Turn #40 plastic torx screw 1 tooth clockwise
(Fig. 3).
B 4. Adjust CO2 (see chapter 2).
C. Converting from NG to LPG
B 1. remove jumper from location JP6 on the control
board (Fig. 4).
B 2. Turn slotted brass screw 3.5 turns clockwise
(Fig. 2).
B 3. Turn #40 plastic torx screw 1 tooth counter
clockwise (Fig. 3).
B 4. Adjust CO2 (see chapter 2).
D. Clean up
B 1. Reinstall yellow painted #40 Torx cover on the
front of gas valve (Fig. 3).
B 2. Rotate brass slotted screw cover up and tighten
yellow painted Philips screw (Fig. 2).
B 3. Reinstall lower wire harness onto control board.
B 4. Reinstall control board access cover (Fig. 1).
B 5. Apply conversion sticker to right side panel above
rating plate. Ensure information is filled out
accurately.
B 6. Reinstall cover and return to service.
6720607679-11.1AL