Outdoor Kit Installation Manual

6 720 645 551
4
Installing outdoor kit
3 Installing outdoor kit
Replace the control panel shield
B Loosen the two Philips head screws located on
bottom rear of cover (see Fig. 2).
Fig. 2 Loosen the two screws
B Remove the front cover panel and replace the
original control panel shield with shield provided in
the kit, see Fig. 3.
Fig. 3 Replace the control panel shield
B After replacing the control panel shield re-position
the front cover.
B 1. Remove the cover plate (A) from the top of the
appliance, as shown in Fig. 4.
Fig. 4
B 2. Attach the supports (B) to the appliance with the
four provided screws, as shown in Fig. 4.
Before mounting the outdoor kit on the appliance:
Remove the exhaust seal from outdoor vent cap:
For condensing appliances only:
B Remove inner seal, see Fig. 5.
Fig. 5 Condensing appliances only
(C1050ES, C1210ESC, C1210ES)
i
This applies for all models except for the
model 940ESO.
Warning: The control panel shield
must always remain closed, except
when making adjustments, to prevent
damage to heater from weather.
6720608547-14.1AL
1.
1.
3.
2.
i
This applies for all models except for the
model 940ESO.
6720645551-16.1V